Can Curt Friction Sway Control be Used on Both Sides of Trailer

Question

Question:

so I have one of these for the passenger side and when it came the model #had and rb at the end for right passenger , I did see in your guys questions and answers that you can just pull it out and flip it over 180 and use it for the drivers side,then the stickers and levers are all up side down. I see in all the pictures and manuals one made for the the drivers side so everything is right side up stickers ect. can you guys get it for drivers side

asked by: Damon

0

Expert Reply:

Curt only has one version of the # 17200 which you can flip around and use on either side as needed. There isn't a different version that has the sticker and plate work but this works well on either side.

expert reply by: Jameson C

0

Answer 1

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 2

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement for…

view full answer...

Answer 3

If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and the…

view full answer...

Answer 4

I recommend to use the Solera 16-1/2' Slider part #LCV000435661 which matches the boxes width exactly so you will not have side overhang like we normally recommend but it is the biggest slide topper available to fit the 198" width of your…

view full answer...

Answer 5

We have toppers that'll work for 2 of your 3 sliders. For your 12 foot 9-1/2 slide, use #LCV000168109 which is designed for slides measuring between 152-157 inches wide. The longest topper we offer is for slides 188-193-3/4 inches, so…

view full answer...

Answer 6

Please note the attached instructions. The Lippert Anti-Billowing Kit for Solera Slide Topper Awnings, #LC78FR should be installed on the end of the awning that is closest to the front of the unit. 1. Make sure awning is fully retracted. 2. Place the…

view full answer...

Answer 7

The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…

view full answer...

Answer 8

Yes, the 7-way to 5-way and 4-way Adapter, #C35FR, will work with your 2005 Land Rover LR3 as long as your factory 7-way trailer connector. This adapter was originally designed for certain European vehicles with incandescent tail lights and factory…

view full answer...

Answer 9

I advise measuring the two spindles that you have and making sure that the parts that you are wanting to interchange will be a compatible fit. I have included a photo that shows where where to take these measurements on your exiting spindles. These…

view full answer...

Answer 10

Great question, we have all that you need to flat tow your 2022 Yukon XL Denali. I will list the items then the details. Blue Ox Base Plate Kit - Removable Arms #BLU58FR. Blue Ox Avail Non-Binding Tow Bar - Motorhome Mount - 2" Hitch - 10,000…

view full answer...

Answer 11

The #37213635 JR Products Replacement Landing Gear Switch you'd mentioned would be a proper replacement for your existing Atwood 70254 landing gear switch. If you wanted the switch, wiring harness and the bezel for the switch, use the Stromberg…

view full answer...