How Long Is the Electric Brake Shoe Return Spring BP07-150

Question

Question:

What is the length of this spring?

asked by: Chad S

0

Expert Reply:

The overall length of the Electric Brake Shoe Return Spring part # BP07-150 is 7-3/4".

expert reply by: Conner L

0

Answer 1

Based on my research Dexter seal 63052 appears to have been used in a military trailer application. I also could not find a current production seal that cross-references with this one. In this case the way to find a new seal is to measure the hub…

view full answer...

Answer 2

Typically mobile home hubs use wheel bolts instead of studs. This rim clamp has hole diameter of 9/16 inch. Most of the wheel bolts we carry that will be long enough to work with the rim clamp are 1/2 inch diameter wheel bolts. If your mobile home…

view full answer...

Answer 3

It sounds like you're looking for a brake adjuster spring for your 10" brakes, so you can use the Replacement Manual-Adjuster Spring for 10" and 12" Electric Trailer Brake Assemblies #BP08-070; this part is…

view full answer...

Answer 4

If you are going to try and find specific replacement parts for a set of electric trailer brakes then you need to know what brand you have and around the time they were made. If you do not have this then you have two options, trial and error or…

view full answer...

Answer 5

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 6

You will use only one spring in the Dexter Replacement Trailer Brake Magnet Kit for Dexter and Hayes / AL-KO 10" Trailer Brakes, #BP01-110. Which spring will depend on which brake system you have. If you have the Dexter brakes you will use…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

How Long Is the Electric Brake Shoe Return Spring BP07-150

Product Page this Question was Asked From

Continue Researching