Availability of Lasalle Bristol RV Waste Valve with Shorter than 60 inch Cable

Question

Question:

Can the cable be shortened for my application?

asked by: Brent

0

Expert Reply:

We sell a shortened cable version of the # 34466N11AB60GM that you referenced with the part # 34466N11AB48GMA which has a 48 inch long cable.

We don't have a way to recommend shortening the cable though.

expert reply by: Jameson C

0

Answer 1

I checked with LaSalle Bristol and they don't offer just the replacement cable. If the cable is broke you will need to replace the entire waste valve for which we offer part #34466N4AB48GMA for black water or part #34466N11AB48GMA for gray water.…

view full answer...

Answer 2

We actually sell a version of the LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank #34466N11AB72GMA that you referenced in a 48 inch long cable version as part #34466N11AB48GMA. I would not recommend attempting to shorten the cable…

view full answer...

Answer 3

There is currently only a 72" cable #TC72PB available to go with the Valterra Waste Valve for RV Gray Water Tank #T1001PBC. If you want a gray water waste valve with a 48" cable you would need the LaSalle Bristol Cable-Actuated RV Waste…

view full answer...

Answer 4

Thank you for the photos! Based on that it looks like you have a spigot to hub black water tank valve, like you mentioned, where the hub end fits over one pipe and the spigot end fits into the other pipe. So for a spigot to hub replacement valve with…

view full answer...

Answer 5

Determining the correct replacement for your old waste valves is going to depend on the brand and length of your current cables. If you have Valterra branded valves you could reuse the cables you have and avoid rerouting new cables. You could simply…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 10

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Availability of Lasalle Bristol RV Waste Valve with Shorter than 60 inch Cable

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching