Replacement Hitch Pin Bolt for Yakima SlickRoc Bike Rack

Question

Question:

Will this pin fit Yakima SlickRock bike rack?

asked by: Mitchell K

0

Expert Reply:

I checked with Yakima and the correct replacement hitch pin setup you'd need for the now discontinued SlickRoc is the part # Y8780022.

expert reply by: Jameson C

0

Answer 1

I measured the bolt that is included in the Yakima Replacement parts kit #Y8780022 and found it has the following dimensions: Overall Length 4-5/8 Hex Head Size 13/16 Thread diameter 1/2 Length of Thread 2-1/2 I prepared a photo with these…

view full answer...

Answer 2

If the nut is stripped inside the anti-rattle insert that is included in the Replacement Hitch Bolt, Nut and Clip for BigHorn 4 Bike Carrier #Y8780022 then you will need to purchase a new kit. Anytime there is a replacement option for equipment…

view full answer...

Answer 3

I spoke with Yakima about your Yakima Quarter ROC Bike Rack 8002533 and they stated that this bike rack was discontinued in 2001 and the hitch bolt is not a replaceable part. I asked if they have any dimensions of this bolt but they could not…

view full answer...

Answer 4

You are right, I pulled both the part #Y8890185 and the #Y8780022 from our warehouse and the only difference is the additional flat washer that is in the #Y8890185.

view full answer...

Answer 5

Good news! I was able to go out to the warehouse and measure the pin that is included in the Replacement Hitch Bolt kit #Y8780022 and found that when placed in the lock you will have 3.66 inches of pin length between the lock and the head of the…

view full answer...

Answer 6

Without knowing what bike rack you have it's hard to say what pin you would have currently, but I did speak to my contact at Yakima and she said that the part #Y8890200 is 4-1/2 inches long which may be longer than what you currently have…

view full answer...

Answer 7

I went and pulled a Replacement Hitch Bolt and Clip for Yakima HoldUp Hitch Mounted Bike Carrier #Y8890200 from our warehouse to measure and found that the bolt has 5/8 inch coarse threads and the size wrench you would need to use to tighten it would…

view full answer...

Answer 8

The Hullavator Pro #TH898 will work just fine with Yakima round bars and will not require any additional hardware like what you mentioned. The only step that you will skip in the instructions is installing the special angled end cap (page 5) but my…

view full answer...

Answer 9

For a replacement hitch pin for your Yakima BuckHorn bike rack you would want the part #Y8780018.

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Replacement Hitch Pin Bolt for Yakima SlickRoc Bike Rack

Product Page this Question was Asked From

Continue Researching