Does Wiring of Lippert Components Power Stabilizer Jack Change In Front and Rear Applications

Question

Question:

Does the wiring change at all if I want to install this for the front and rear?

asked by: Cory S

0

Expert Reply:

The wiring of the Lippert Components High-Speed Power Stabilizer Jack # LC298707 that you referenced is the exact same for if used at the front or rear of an RV. I attached a diagram that shows how everything wires up for you to check out as well as an install video link.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I have attached a parts breakdown of the Lippert Components Power Stabilizer Jack but I am not sure which roll pin you are referring to. That said, it should like the shear pin may have been damaged so in which case you would need to replace the…

view full answer...

Answer 2

I attached a picture that shows the install instructions for the Lippert Components High-Speed Power Stabilizer Jack #LC298707 that you referenced and in it you'll notice a set distance isn't specified for where it has to install on…

view full answer...

Answer 3

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 7

The Lippert High-Speed Power Stabilizer Jack part #LC298707 would be an excellent replacement option for the now discontinued 337199 model. It does come with a new switch so you can either wire this up or reuse the existing, either way the switch…

view full answer...

Answer 8

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 9

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 10

The direct replacement for your Lippert Model 113407 stabilizer jack is part #LC369774. I confirmed this with my contact at Lippert. It requires an easy bolt-on installation.

view full answer...

Does Wiring of Lippert Components Power Stabilizer Jack Change In Front and Rear Applications

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching