What Thickness of Metal Can Chrome Edge Trim # SAT012ET Fit On

Question

Question:

What is the smallest thickness of metal this will work on? Thanks

asked by: Tim

0

Expert Reply:

The Chrome Edge Trim # SAT012ET can fit metal thicknesses up to 1/8 of an inch. It doesn't have a minimum thickness stated. Basically anything you'll have on the exterior of an RV with less than 1/8 of an inch is going to work.

expert reply by: Jameson C

0

Answer 1

We carry quite a few different types/styles of trim so I've attached a link to our selection below so you can take a look. If you still want to send those pictures I can take a look myself and try to find the correct match. When you replace…

view full answer...

Answer 2

The Small Edge Trim for Enclosed Trailer part #362ET4119-25 slides over the sharp edge you're trying to cover. If you look at the video I've linked you can see that the trim has an opening for the edge being covered to slide into. It…

view full answer...

Answer 3

No it does not have an adhesive backing. It has an open slit that gets pressed onto an edge.

view full answer...

Answer 4

My contact at Redline told me that the outside diameter of the Chrome Trim #SA1012ET would be right at 5/16 of an inch and the inner diameter 1/8 of an inch. He said the trim isn't a perfect circle so the dimensions fluctuate a little bit.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 6

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

The correct rail kit you need for your Demco Hijacker Autoslide part #DM8550040 to fit your 2016 Ford F-350 is the part #DM8552000-71.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 12

It is certainly possible for the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY58GR to work on your 2020 Ford F-250 Super Duty short bed, but there are likely going to be clearance issues as these are meant for long bed trucks. That…

view full answer...

What Thickness of Metal Can Chrome Edge Trim # SAT012ET Fit On

Product Page this Question was Asked From

Continue Researching