Does Chrome Edge Trim # SAT012ET Have an Adhesive Backing

Question

Question:

Does this have a self adhesive in the back of it? I

asked by: Erik

0

Expert Reply:

No it does not have an adhesive backing. It has an open slit that gets pressed onto an edge.

expert reply by: Jameson C

0

Answer 1

My contact at Redline told me that the outside diameter of the Chrome Trim #SA1012ET would be right at 5/16 of an inch and the inner diameter 1/8 of an inch. He said the trim isn't a perfect circle so the dimensions fluctuate a little bit.…

view full answer...

Answer 2

In order to pick out a direct replacement for the landing gear on your trailer we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then…

view full answer...

Answer 3

Yes, you can use the Chrome Edge Trim #SAT012ET to fill where the fenders meet the trailer body in the way you are describing.

view full answer...

Answer 4

The Chrome Edge Trim #SAT012ET can fit metal thicknesses up to 1/8 of an inch. It doesn't have a minimum thickness stated. Basically anything you'll have on the exterior of an RV with less than 1/8 of an inch is going to work.

view full answer...

Answer 5

We carry quite a few different types/styles of trim so I've attached a link to our selection below so you can take a look. If you still want to send those pictures I can take a look myself and try to find the correct match. When you replace…

view full answer...

Answer 6

The Chrome Edge Trim - 50' Roll #SAT012ET is a plastic edging that is flexible and has the adhesive for permanent installation. It fits up to 1/8 inch thick material. It is not chrome plated but rather has a permanent chrome finish.

view full answer...

Answer 7

The Small Edge Trim for Enclosed Trailer part #362ET4119-25 slides over the sharp edge you're trying to cover. If you look at the video I've linked you can see that the trim has an opening for the edge being covered to slide into. It…

view full answer...

Answer 8

Wheel torque specs vary based on stud diameter, wheel diameter and wheel material. The linked chart shows you commonly recommended torque specs for a range of studs and wheels. For 1/2-inch wheel studs and a 14-inch steel trailer wheel you will use…

view full answer...

Answer 9

The Drip Rail Rubber Railing for RVs and Trailers, #SR83FR is a great product that easily installs using an adhesive backing. This drip rail diverts water in trouble spots away from doors and windows but this high quality EPDM constructed product…

view full answer...

Answer 10

The most similar interior light we have to the #RVIL21 that uses LED instead is the part #LIL9L which has a slightly different shape but is essentially the same assembly.

view full answer...

Answer 11

I do have a way for you to increase the visibility of your t-load truck bed extender but we currently do not have a set of lights that are designed to work with your setup. Instead, the best option I have for you would be to use a reflector like…

view full answer...

Answer 12

We do offer drip rail which we sell in 10 foot lengths as part #SR83FR. The rail would work great mounted above the door you mention, and would do a great job of keeping rain out of the top edge of the door. For the door edges, I'd use…

view full answer...

Does Chrome Edge Trim # SAT012ET Have an Adhesive Backing

Product Page this Question was Asked From

Continue Researching