Can The Tornado 360-Degree RV Holding Tank Rinser Be Used For A Grey Tank

Question

Question:

cant this product be used for a grey tank?

asked by: Anthony S

0

Expert Reply:

Yes, the Tornado 360-Degree RV Holding Tank Rinser # CAM40126 is a permanent solution for your grey tank. This will install permanently and will be able to rinse out more areas of the tank than traditional rinsing methods. Included is a video review resource.

expert reply by: Patrick R

0

Answer 1

We don't have a video but the way that the Tornado 360-Degree RV Holding Tank Rinser #CAM40126 works is a lot like how a yard sprinkler works. It uses water pressure from the hose to spin the nozzle around to cover more of the inside of the…

view full answer...

Answer 2

A hitch extender or adapter, like the dual-receiver MT70070, cannot be used with weight distribution (WD) systems. As you note, use of ANY adapter has the unavoidable side-effect of cutting your hitch's capacity by 50-percent. An adapter would…

view full answer...

Answer 3

The only hitch extension we offer that is compatible with weight distribution hitches is the Titan Hitch Box Extension and Reducer #RP45292. This product is designed to fit hitches with a 2-1/2 inch receiver opening and then reduces down to a 2 inch…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 11

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 12

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Can The Tornado 360-Degree RV Holding Tank Rinser Be Used For A Grey Tank

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching