Replacement 2-5/16 inch Hitch Ball for Andersen Ultimate Connection

Question

Question:

I have a Anderson hitch with a 2inch ball and now I need a 2 5/16 ball. What part do i need?

asked by: Bobby H

0

Expert Reply:

The Replacement Ball for Andersen Ultimate Connection 5th Wheel Trailer Hitch System # AM3201 that you referenced is the correct replacement for a 2-5/16 inch ball for the Andersen Ultimate connection it sounds like you have.

expert reply by: Jameson C

0

Answer 1

Lippert only offers the #LC377962 in black. If you wanted to paint it silver though there's no reason you couldn't.

view full answer...

Answer 2

The part number you need for a replacement hitch ball for your Andersen Ultimate Connection part #AM3200 is the part #AM3201. There are no greaseless balls that are designed as replacement balls for this product, but the #AM3201 is made of aluminum…

view full answer...

Answer 3

While we do have the correct replacement ball for your Andersen Ultimate Connection 5th Wheel Trailer Hitch #AM3200, Andersen stopped making the ball with three holes, and now only has the ball with two holes: - Replacement Ball for Andersen Ultimate…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 10

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

view full answer...

Answer 11

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 12

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...

Replacement 2-5/16 inch Hitch Ball for Andersen Ultimate Connection

Product Page this Question was Asked From

Continue Researching