Pop & Lock Locking Tailgate Handle for 2019 Honda Ridgeline

Question

Question:

the tailgate on the Ridgeline opens like a truck tailgate and like a door. Does the pollock prevent opening the tailgate both ways

asked by: Leolin B

1

Helpful Expert Reply:

The Pop & Lock # PL6200 locking tailgate handle replaces the OEM handle and will prevent your tailgate from being opened period, whether it be swinging to the side or tilting downward. If you wanted the lock to be powered along with your doors, you'd add the # PL8630 power upgrade kit. This will also work if you have the factory back up camera.

expert reply by: Mike L

1

Answer 1

You will need the Pop & Lock Custom Tailgate Handle #PL8675 to add power locks to your 2019 Honda Ridgeline. The Power Lock Upgrade Kit #PL8630 you found is only an upgrade to the Kit #PL6200 which fits models without a lock already on the…

view full answer...

Answer 2

The wires under the hood for power to the factory 7-Way and power for a brake controller under the dash are sometimes rather hard to see. The wire for the factory 7-Way power is located under the master cylinder and is taped to the wiring harness…

view full answer...

Answer 3

To configure the locking mechanism on your 2012 Honda Ridgeline with the Pop & Lock Custom Tailgate Lock part #PAL8600, you will need to make two connections. The first connection involves attaching the green wire (lock) from the tailgate lock to…

view full answer...

Answer 4

According to the folks at AirLift, their air helper spring systems are compatible with Daystar Cradles, but using them will void the product warranty of the air helper springs. Some folks at Firestone have told us the same about their Ride-Rite…

view full answer...

Answer 5

You do not need to replace the handle on your 2014 Honda Ridgeline to install the Pop and Lock #PAL6100. This will not interfere with your existing back up camera, it will install on the on the interior side of your existing tailgate handle system.…

view full answer...

Answer 6

The Bauer Products T-Handle Lock for Truck Caps #BA47VR is designed to fit standard truck caps like what you have so this would work well for you.

view full answer...

Answer 7

Yes, we do have locking t-handles. I recommend the Bauer Products T-Handle Lock for Truck Caps item #BA47VR. This t-handle is 3-1/2" long x 2" wide, the length of shaft is 2", and the distance between mounting holes center to center is…

view full answer...

Answer 8

I have the perfect solution for you, Chris! The 13.5K Btu Advent Air Low Profile RV Air Conditioner for Dometic Setup with a Start Capacitor is a great replacement as it has the same output rating of your current AC unit, it has a plug to plug right…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Good question Chuck, but you won't actually have to remove the etrailer logo on the Pop & Lock Custom Tailgate Lock with Handle #PL6200. It won't come with the product, we only put that sticker on for our photos to try and prevent people…

view full answer...

Pop & Lock Locking Tailgate Handle for 2019 Honda Ridgeline

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching