Will B&W Turnoverball Underbed Gooseneck Trailer Hitch Fit 2018 Ford F-150 Diesel

Question

Question:

any problems bolting this onto my 2018 f150 with 3.0 diesel?

asked by: Scott

0

Expert Reply:

B&W doesn't call out any issues with installing the Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit # BW77FR on a 2018 Ford F-150 with the 3.0 diesel so I don't see any problems for the installation.

expert reply by: Jon G

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

I went ahead and checked with Curt and and the Curt Double Lock, Flip and Store Underbed Gooseneck Hitch #C60722 is the correct fit for a gooseneck on your 2001 Ford F-150. Having said that, your truck does need to have the holes in the side rails,…

view full answer...

Answer 6

Yes, you are going to also need the Demco Autoslide Capture Plates for Trailair Rota-Flex Pin Boxes #DM6171 when using the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040 with your Road Armor pin box. For a suspension enhancement I…

view full answer...

Answer 7

To replace your AL-KO 568303 seal you will want the Oil Seal #91030. This seal has the same inner diameter of 2.750 inches and outer diameter of 3.779 inches. It is a confirmed fit for your #99 spindle that uses the AL-KO 568303 seal.

view full answer...

Answer 8

Hi Tyler, When adding in air springs on a lifted vehicle the proper way to determine the correct sized spacer is to first install the upper and lower brackets and then measure the distance between them and subtract the height of the air spring bellow…

view full answer...

Answer 9

I spoke with my B&W representative who confirms that to install their GNRK1121 #BW77FR Turnover Ball hitch on a 2021 Ford F-150, the center of the 4 inch hole for the gooseneck ball would be placed 42-5/8 inches forward of the rear edge of the…

view full answer...