Will Hopkins HM50002 Smart Hitch Still Work if 7-Way Trailer Isn't Being Used

Question

Question:

I currently have the 7 pin and 4 pin connections on my rear bumper. If I only use the 4 pin for hauling my trailer, and dont have any need for the 7 pin at this time, will the reverse monitor still work?

asked by: Robert E

0

Expert Reply:

It sure will. The # HM50002 camera system will still get the signal from the reverse lamps that turn on the system even though the 7-way connector isn't being used. I've linked you to a product description video featuring the Hopkins Smart Hitch camera system.

expert reply by: Mike L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

I reached out to my contact at firestone to confirm a few things. If the compressor is running, it should be filling the bags. The compressor is either going to build air pressure, or not build pressure. So if it is running when the bags are full,…

view full answer...

Answer 4

The Vision X 9007 Halogen Headlight Bulbs with Relay Harness #VX-H9007-R uses a combination of 16 and 18 gauge wire. It may seem thin but with short distances like with this harness 16 and 18 gauge wires can actually handle a surprising amount of…

view full answer...

Answer 5

In order to swap your surge brakes to electric over hydraulic, you're going to need to change out your actuator and add a proper brake controller. For an actuator I'd recommend going with the Hydrastar Electric Over Hydraulic Actuator for…

view full answer...

Answer 6

I do not see that Toyota offered a factory brake controller for your 2006 Toyota Tundra so you will need an aftermarket brake controller. As long as you have the factory 7-way you will be able to install a brake controller with the Tekonsha Plug-In…

view full answer...

Answer 7

As long as you don't have the factory Air Suspension or the Rebel model you'll want the Firestone Coil-to-Air-Spring Conversion Kit #F2595 for your 2018 Ram 1500. This is an air spring kit that can be adjusted to fit your towing/hauling needs…

view full answer...

Answer 8

The best way to find the correct replacement for your equalizer is by measuring the distance from the front shackle hole to rear shackle hole on your current equalizer. The 33" AllTrek #MR89DR has the holes spaced 6-1/2" on center while the…

view full answer...

Answer 9

I do have an option for you but in order to switch an actuator from disc to drum brakes you'd need a new master cylinder. Unfortunately, we don't have any replacement parts for the Tie Down Engineering LP8500 as it's discontinued.…

view full answer...