Can I Remove Brass Fittings From Propane Regulator and Plug Hoses Directly Into Regulator?  

There are differences that the colors reference for the Type 1 Propane connectors based on the spring tension and flow rate. The light green connectors are rated for Rated for 200,000 Btu per hour. The black are rated for 70,000-100,000 Btu per hour.…

Searching by part number it appears the MB Sturgis Propane Hose Assembly #100383-48-MBS would be the replacemement part you need for at least the 18CE Cavagna Group replacement. The picture received on our end was a duplicate and you mention…

There isn't really any advice I have on removing the quick disconnect fitting other than getting a wrench and plenty of elbow grease. It's in a POL thread which means it's a left-hand thread so keep that in mind. Once you get the quick…

From the picture that you attached it looks like the regulator has a 1/4" SAE inverted flare, like the Camco Automatic Changeover 2-Stage Propane Regulator #CAM59005 does. This means that only hoses that have the 1/4" male inverted flare,…

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

Yes, the MB Sturgis Propane Hose w/ Back Check part #100473-30-MBS would replace the leader hoses on your trailer that lead from the propane tanks to the propane regulator. All of the leader hoses have back check valves. If you would like to upgrade…

I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the necessary…

It looks like what you have there are dual propane tanks, so a dual propane regulator will be needed. The age of the trailer doesn't matter so long as the fittings on the tanks are current. So what you need is the Compact Low Pressure 2-Stage…

The JR Products Automatic Changeover 2-Stage Propane Regulator #37207-30395 should be set to give you 11" WC straight from the factory. The pressure will still be the same so there won't be an issue with the new regulator having a higher BTU…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…