Dimensions of Weld-On Brackets for Ultra-Fab Deluxe Electric Landing Gear Set

Question

Question:

Hi there I am curious about the size of the weld on brackets ? I see some dimensions posted but not all of them. I need to repair the area that will get the the weld on brackets. Thank you. Mainly I would like to know the width measurement.

asked by: Matt G

0

Expert Reply:

Attached is a photo showing the dimensions of the weld-on brackets that come with the Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010. They measure about 2" tall and the blue measurement you see in the picture is the area that the landing gear will fit inside.

expert reply by: Jon G

0

click to enlarge

Answer 1

The Ultra-Fab Deluxe Electric Landing Gear Set part #UF17-943010 would not be a direct fit for the brackets mounted on your trailer as the spacing needed is a few inches larger than what you have now. That said, the landing gear set actually comes…

view full answer...

Answer 2

I spoke with my contact at Stromberg Carlson and the Replacement Lead Jack with Drop Leg, #LG-179013, is the same part as the Lippert Universal Fit Lead Landing Gear, #179013. The only difference between the two products is that they are sold through…

view full answer...

Answer 3

In order for a 'right out of the box' fit for the Ultra-Fab #UF17-943010 fifth wheel landing gear, the underside of your top mounting bracket and the underside of your bottom mounting bracket would need to be 19-1/8 inches apart, as shown in…

view full answer...

Answer 4

I am not sure which dimensions you need. We have a picture that shows the dimensions on the product page. It is the very last thumbnail right next to the main picture. And the instructions are linked on the page, right hand side with even more…

view full answer...

Answer 5

The Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs #UF17-943010 has a measurement of 13-1/2 inches from the top of the highest tab to the top of the middle tab. Then from the top of the highest tab to the top of the bottom…

view full answer...

Answer 6

If you have both weld stops on the same side of the brackets on the RV they wouldn't be able to jack up the trailer and then also not fall once they've retracted. There is quite a bit of force on the jack when they are lifting a trailer up,…

view full answer...

Answer 7

The Ultra-Fab Deluxe Electric Landing Gear Set #UF17-943010 referenced in your question is a great landing gear system that features dual electric jacks that will raise and lower at just the flip of a switch. The jacks themselves can operate…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 11

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 12

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Dimensions of Weld-On Brackets for Ultra-Fab Deluxe Electric Landing Gear Set

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching