Ladder Rack with Over Cab Extension that Fits 2017 Toyota Tacoma w Extended Cab

Question

Question:

I have a 2017 Toyota Tacoma with an extended cab. I want the over the cab ladder rack.The bed rails are not the standard bed rails. they flare inward in the back by the tailgate and the the bed rails are not accessible due to the bed and side rails seem to be all incorporated together. Is there a different bracket and mounting system for this truck? Thx

asked by: Mike

0

Expert Reply:

For your 2017 Toyota Tacoma extended cab we have the Thule over the cab ladder rack part # TH37005XT-EX as a confirmed fit. This fits versions of your truck that have the deck rail system and those that do not have the deck rail system. This does come with the correct brackets to fit your bed rail design as well.

expert reply by: Jameson C

0

Answer 1

For your 2017 Toyota Tacoma Double Cab Short Bed, I recommend the TracRac TracONE Ladder Rack for Toyota Tacoma - Over-the-Cab Extension - 800 lbs, #TH27000XT-XK4EX, if you have the deck rail system. This rack is a sturdy, rustproof aluminum lader…

view full answer...

Answer 2

To carry lumber and tools with your 2023 Toyota Tacoma you are going to want the Thule TracRac TracONE Truck Bed Ladder Rack item #TH27000XTB-XK4B. This fits both the 5 foot beds and 6 foot beds with the deck rail system. The Thule ladder rack system…

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

Most critical to trailer tire performance and durability are 1) proper inflation 2) observance of the tire's rated load capacity and 3) observance of the tire's speed rating. If either of these factors is off the mark then the tire will tend…

view full answer...

Answer 6

I'm pretty sure you are correct that the Coil SumoSprings Custom Helper Springs #CSS-1145R will fit your 2018 Toyota Highlander, however, we haven't had the chance to test this out and SuperSprings doesn't have this listed in their…

view full answer...

Answer 7

We only have the products listed on our website. I just double-checked to see if there was anything matching your descripton. The 4 microwave/convection/OTR ovens are all well over your 24" wide location. One of the smallest is the Furrion…

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Ladder Rack with Over Cab Extension that Fits 2017 Toyota Tacoma w Extended Cab

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching