bing tracking image
Q & A Icon

How Does Furrion Vision S Side Camera Wire Up to Trailer Wiring  

Question:

I have a new 2020 Grand Design Reflection 150 5th wheel trailer and want to install new Furrion Vision S side cameras on it. I pulled the side marker light off the trailer and found it has two wires, a black and a white see picture. The Furrion camera has three wires, a brown V+ Traffic, a red V+ Camera, and a black Ground. My Rear camera was installed by the dealer and works with the running lights. Which wires get connected where??? Will black go to black and the Brown and Red connect to the white? Also, are the cameras specific to a side of the trailer? Should the pairing button be on the top or bottom? Any advice is appreciated.

0

Expert Reply:

For the Furrion Vision S side camera/marker light kit # FCE48TASL the brown wire goes to running light circuit for the light to come one, the black goes to ground, and the red is your trigger wire for the camera to turn on. This allows you to decide what circuit you want to activate the camera. You can run it to the running lights so that any time you want the camera to be selectable from the monitor all you have to do is turn on the running/head lights. This is the most common choice and what I recommend. So for your situation you'd run the brown and the red wire of the camera to the running light circuit of your trailer.

expert reply by:
0
Jameson C

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>