Cut Out Size for Grommet to Install Amber Side Marker Light STL75AB

Question

Question:

what size hole do i need to cut for this light to fit into

asked by: J.w D

1

Helpful Expert Reply:

To flush-mount install the Optronics LED Side Marker Light and Mid-Ship Turn Signal # STL75AB you will need to use PVC Grommet # a70gb which requires a 7-5/8" wide x 3-3/8" tall hole, as you can see in the cut out I added of the dimensions of this grommet.

You will also need 3-Wire Pigtail for Optronics Trailer Lights # A47PB to complete your installation; this pigtail plugs into the light so you can wire it to your trailer.

I have added links to video reviews and installs for you to check out as well which should be helpful.

expert reply by: Kyle S

1

click to enlarge

Answer 1

Based on the number you mentioned and other customers who have mentioned it the replacement side lens SHOULD be the part #AL17RB. I say should because the SAE number isn't a part number which means it's not always reliable to pick…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 4

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 7

Hey Medic, so the Kenda ST235/75R15 Radial Off-Road Trailer Tire #KE68JR was designed for off-road traction but it is going to do really well in the wet and snowy conditions. Based on what you are looking for these are going to work well.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...