Are There Instructions for Installing Replacement Heater Pad # 674864

Question

Question:

Is there a step by step to replace the heating pad

asked by: Jeff B

0

Expert Reply:

Thomas Payne does not offer specific instructions for installing the Replacement Heater Pad # 674864 that you referenced but it's more or less disassembling the couch cushions to access the pad, unplugging and remove the old heater and reversing the process to install everything.

expert reply by: Jameson C

0

Answer 1

You will have to go from the side or underneath. Then you can unplug and remove the old pad and replace it with the Replacement 29-Volt Seat Heating Pad for Thomas Payne Seismic Series RV Couches and Chairs #674864. If you need to replace the entire…

view full answer...

Answer 2

I cannot recommend you alter the location of the heating pad on the Thomas Payne Seismic Dual Power Reclining RV Loveseat. That said, if you do not wish to have the heated seat feature this can be turned off via the controls on the cup holder. If you…

view full answer...

Answer 3

If your Thomas Payne recliner has the power recline function, then the 29 volt, #674864 is the correct heating pad replacement. If not, then the Replacement 12 Volt Seat Heating Pad for Thomas Payne RV Theatre Seating #LC38UD is the correct…

view full answer...

Answer 4

Lippert, who make the Thomas Payne line of furniture, does not offer specific instructions for installing the Replacement Heater Pad #674864 that you referenced. Installing this heating pad requires more or less disassembling the couch cushions to…

view full answer...

Answer 5

There is an adapter that will allow you to use the Furrion back-up camera on your 2021 Chevy Silverado, and no waiting list is needed, it is available with this part: - 7-Way Vehicle Power Adapter w/ Power Switch for Furrion RV Observation Camera…

view full answer...

Answer 6

The Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF will work on a 2019 Chevrolet Silverado but you need an adapter, the 7-Way Vehicle Power Adapter Cable for Furrion RV Observation Camera part #FR87PR. The running light circuit…

view full answer...

Answer 7

Thanks for the picture of your Thomas Payne actuator setup. Based on seeing that we know the part #SC96MR is the correct replacement.

view full answer...

Answer 8

You could test the wiring of the heating pad with a circuit tester like the part #PTW2993 to see if there is voltage to it when the heating function is on. If you are getting voltage but the seat isn't heating you'd want to replace the heater…

view full answer...

Answer 9

I spoke with my contact at Lippert who said that either the heater is bad or the control box needs to be replaced on your Thomas Payne Momentum recliner. To test the heater unplug the red and black wires from the control box (located behind and under…

view full answer...

Answer 10

We have the replacement heater pad you mentioned available with part #674864. This is the replacement 29V heater pad for the Thomas Payne Seismic line of reclining sofas. The Replacement Seat Heater Kit #195-000113 that you referenced is just the…

view full answer...

Answer 11

This sounds like a faulty control box, and unfortunately that is a pretty common issue with these recliners. To fix it, you'll just have to replace your control box with the Replacement Control Box for Thomas Payne Momentum Recliners and Sofas…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Are There Instructions for Installing Replacement Heater Pad # 674864

Product Page this Question was Asked From

Continue Researching