Cutting Hole in Cover to Install Extang Replacement Tail Clamp Assembly
Question:
How do you cut an access hole? What exactly does that mean???
asked by: Ray
0
Expert Reply:
To install the Extang Replacement Tail Clamp Assembly # EX1035 into an Extang Solid Fold you will need to cut a notch in the channel. A spot near the middle of the cover is preferred.
Usually you'll only need to make a notch on one side of the channel, to create an opening just large enough to both remove the original clamp and then to install the new one into the channel and then slide it back into position.
My contact at Extang indicated that usually a Dremel-type rotary tool can do this job most easily.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Tail Clamp Assembly for Extang Solid Fold and Trifecta Tonneau Covers - Qty 1
- Accessories and Parts
- Tonneau Cover
- Clamps
- Extang Solid Fold
- Extang Trifecta
- Extang
more information >
Continue Researching
- Video: Review of Extang - Tonneau Covers - EX1035
- Shop: Replacement Tail Clamp Assembly for Extang Solid Fold and Trifecta Tonneau Covers - Qty 1
- Shop: Replacement Tailgate Hinge for Extang Trifecta and eMax Tonneau Covers - Qty 1
- Q&A: Installing the Replacement Tail Clamp Assembly for Extang Trifecta Tonneau Cover
- Q&A: Replacement Rear Latch Clamp for Extang Solid Fold
- Q&A: Replacement Tail Clamp Assembly Recommendation for Extang Solid Fold Tonneau Cover
- Q&A: Does Cover Need to be Removed to Install Replacement Tail Clamp Assembly for Extang Solid Fold
- Shop: Replacement Tail Panel Assembly for Extang Solid Fold 2.0 Hard Tonneau Cover
- Shop: Replacement Cab Clamp Assembly for Extang Trifecta Tonneau Covers - Qty 1
- Shop: Tailgate
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: air bags
- Video: Choosing the Right Brake Controller
- Shop: Trailer Wiring
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: trailer brake controller
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Suspension Enhancement
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Search Results: trailer jack
- Search Results: hitch
- Article: How to Measure for Trailer Hitch Drop
- Shop: Brake Controller
Explore Expert Info
![Our Expert]()
on Accessories and Parts
on Accessories and Parts
