Dimensions of Buyers Products Heavy-Duty Square Jack

Question

Question:

NEED TO KNOW THE DIMENSIONS OF PART # 337009141OH SQUARE 10-12K LBS JACK. TOTAL HEIGHT EXT.. THANKS

asked by: PATRICK

0

Expert Reply:

I have a number of dimensions for you of the Buyers Products Heavy-Duty 4" Square Jack w/ Side Pin Drop Leg - Sidewind - 26" Lift - 12K # 3370091410H.

It has a 4" square tube, an 8" x 8-1/2" foot pad, is 28" tall when it is retracted and 40-1/2" when it is extended. That means it has a total of 12-1/2" of travel.

I have added a link to a video review of this jack for you to check out as well.

expert reply by: Kyle S

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Basically you fill up the hub as much as you can through the hole in the cap like the part #RG04-300 and once the oil level is at the bottom of the cap hole it's as full as it needs to be.

view full answer...

Answer 3

I recommend the Kodiak Synthetic Bearing Oil for Oil Bath Hubs - 8 oz Bottle #XLPROLUBE. It is a 90 weight synthetic oil. Dexter bought out Kodiak so this meets their specifications. I've also attached a photo of Dexter's recommended Oil…

view full answer...

Answer 4

The Holland Binkley model 48,000 series jacks are very similar to the Bulldog Square Jack - Drop Leg w/ Spring Return #BD182815 which can utilize the Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity #BD1824200100. Your current…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

view full answer...

Answer 7

To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

I checked with Ram and without the leg the Square Direct Weld Jack item #TJD-15000SP-F is right at 22" long.

view full answer...

Dimensions of Buyers Products Heavy-Duty Square Jack

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching