Availability of U-Bolts that are 2 inches Wide and 4 inches Long

Question

Question:

Do u have any of these available for purchase? 2” wide 3” long galvanized u bolts Need them to secure guide on posts to boat trailer

asked by: Ken T

0

Expert Reply:

The u-bolts we offer with the most similar dimensions to what you need is the part # UBZC716X212X400 which is 4 inches long and has an inner width of 2-1/8 inches. Normally this is used to secure 2 inch square trailer axles.

I attached a review video for this for you to check out as well.

expert reply by: Jameson C

0

Answer 1

I spoke with my contact at CE Smith and the wood in the Carpeted Bunk Boards #CE27820 is a non-treated wood. The carpet though is marine grade carpeting.

view full answer...

Answer 2

The boat bunks like the part #CE27820 are usually made from a non-treated pine wood.

view full answer...

Answer 3

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…

view full answer...

Answer 4

The CE Smith Carpeted Bunk Boards for Boat Trailers part #CE27820 are simply made of untreated lumber wrapped in marine grade carpet.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 10

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Availability of U-Bolts that are 2 inches Wide and 4 inches Long

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching