How to Install Pal Nuts

Question

Question:

How are these supposed to be put on?

asked by: Rebecca

0

Expert Reply:

The Replacement Pal Nuts # CE10800A will just need to be pressed onto the 1/2" diameter shaft for your roller. You may need to boop them on with a rubber mallet if they don't go on easily.

expert reply by: Jon G

0

Answer 1

The Yates Endcap for Boat Trailer Rollers part #YR130-4 will work great with the Yates Bow Roller for Boat Trailers part #YR300BLK. If you need a roller shaft as well, I recommend the Roller Shaft with Pal Nuts part #CE10701A.

view full answer...

Answer 2

In order to find the correct replacement spool roller for your boat trailer, you would need to measure from the inside of each mounting bracket. The 4-1/2" long measurement that you provided is not common and we would not have anything…

view full answer...

Answer 3

The Yates Spool Roller for Boat Trailers #YR4163-4P has a polyethylene inner sleeve to allow for the roller to easily turn on the 1/2" shaft.

view full answer...

Answer 4

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 5

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 6

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 7

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 8

The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…

view full answer...

Answer 9

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 10

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

How to Install Pal Nuts

Product Page this Question was Asked From

Continue Researching