Weight Distribution Shank for Curt System C17120 with Two Addition Holes for More Drop

Question

Question:

My camper is very low to the ground and I think I need a shank that is at least one or two more holes lower than the one that comes with the 17300 hitch, which is what I have. Do you have a recommendation? I have the PIN in the head with 0 washers and 7 links of chain on the bars. the bars are parallel to the camper, the truck is squatting 1 3/4inch in the rear and the camper is still high on the tongue side.

asked by: John A

0

Expert Reply:

For a weight distribution shank for our Curt system part # 17300 that has two more holes than the one that's included you would want the part # 17120 and you'd be set!

expert reply by: Jameson C

0

Answer 1

Hi Bob; since there is less stability at the rear of your 2013 Thor ACE 30.1 the rear anti-sway bar will have the greatest impact. The correct part for your motorhome is the Roadmaster Rear Anti-Sway Bar #RM-1139-146. It sounds like you plan on…

view full answer...

Answer 2

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 3

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 4

I found the online version of the install instructions for the Exact Center stabilizers like the #RM47MR. What's fun is that just when you think you have found the correct step to address your problem it tells you to continue to the next step.…

view full answer...

Answer 5

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 6

The Roadmaster Rear Anti-Sway Bar for Motorhomes #RM-1139-143 can use your factory u-bolts if they are long enough. If they are not, then Roadmaster recommends using the 7/8 inch diameter u-bolts that are longer (most likely the larger diameter due…

view full answer...

Weight Distribution Shank for Curt System C17120 with Two Addition Holes for More Drop

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching