Replacement Rear Wheel Assembly for Yakima HoldUp Bike Rack

Question

Question:

My Yakima holdup black mode 2 inch hitch was rear ended by a car - this has bent the rear support arm. Do you have a replacement arm only rest of the assembly is OK. Please advise details. Thanks.

asked by: Noriel D

0

Expert Reply:

I'm sorry to hear that you were hit by a car (hopefully you're ok!) and we do have exactly what you need, though the arm by itself is not something that is available from Yakima as a replacement part.

For your Yakima HoldUp 2-Bike Rack # Y02443 you will need the Replacement Rear Wheel Assembly for Yakima HoldUp Bike Carriers # 8890281.

Just in the interest of thoroughness (because front and rear can be confusing on bike racks) I did add a photo showing the difference between the Rear and Replacement Front Wheel Assembly # 8890280.

expert reply by: Kyle S

0

click to enlarge

Answer 1

We do have the correct part for you, but the 8880833 is only a fit for the Yakima HoldUp EVO Bike Rack , as opposed to the standard Yakima HoldUp bike rack. Based on your photo, you do not have the EVO, you have the standard HoldUp. The arms are not…

view full answer...

Answer 2

Yakima does not recommend using the HoldUp Rack on motor homes because a bike rack mounted on the rear of a motor home will be subject to more shaking and jarring than would be experienced when mounted in the receiver on a passenger vehicle. This is…

view full answer...

Answer 3

According to the folks in the engineering department at SuperSprings, the manufacturer of SumoSprings it is acceptable to cut down the SumoSprings if necessary, but be aware that doing so will void the product warranty. SuperSprings recommends…

view full answer...

Answer 4

You definitely can cut the SumoSprings Trailer Helper Springs #TSS-107-40 to fit your application if you don't have enough room. We have confirmed this with SuperSprings on multiple occasions. You might also want to make sure that you haven't…

view full answer...

Answer 5

Fan-Tastic does not offer replacement circuit boards for their roof vents. We used to have an upgrade kit that fit your specific roof vent so best option would be to replace the entire vent with part #FV803350.

view full answer...

Answer 6

We have a very similar Fan-Tastic roof vent to the #FV801250 that does have a rain sensor, but this one does not. Since this is a manual lift lid there'd be no way to automatically close the lid if rain was sensed. So instead you'd want the…

view full answer...

Answer 7

Yes, the Fan-Tastic Vent Roof Vent #FV803350 has a rain sensor that will close when it rains or snows but then re-open once it dries. The fan will also automatically re-start once the dome has opened.

view full answer...

Answer 8

First thing you will want to check is that the fan has power and is grounding properly. You can try using jumper wires to the vent wiring that are run to known ground and power to see if that works. Next, you can check the fuse of the fan to make…

view full answer...

Answer 9

An upgrade kit simply makes the lid a powered lift, so it won't work no, you'll need to replace your Fan-Tastic Vent fan, which you can do with the following: - Fan-Tastic Vent Roof Vent w/ 12V Fan and Thermostat #FV803350

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...