Circuit Board Replacement Solution for Fan-Tastic Roof Vent 2000

Question

Question:

I need the printed circuit board for the Fantastic Vent model 2000. Any suggestions on a supplier. Thanks

asked by: Dick S

0

Expert Reply:

Fan-Tastic does not offer replacement circuit boards for their roof vents. We used to have an upgrade kit that fit your specific roof vent so best option would be to replace the entire vent with part # FV803350.

expert reply by: Jameson C

0

Answer 1

First thing you will want to check is that the fan has power and is grounding properly. You can try using jumper wires to the vent wiring that are run to known ground and power to see if that works. Next, you can check the fuse of the fan to make…

view full answer...

Answer 2

I can see why you would ask this question. Since Fantastic Fan is not very specific about which arrows, my only advice is to try the up and down arrows for both the speed and the temp separately until the remote programs. The programming process…

view full answer...

Answer 3

Fan-Tastic does offer a reversible powered fan with power lift and a remote control as part #FV807350. You can see a product description video by using the provided link.

view full answer...

Answer 4

I do have a solution for you that doesn't involve replacing your entire unit, but the Fan-Tastic Vent Roof Vent #FV803350, does not have a receiver built into it, so it doesn't have the option to operate through a remote. Therefore, using its…

view full answer...

Answer 5

Thank you for the info and pictures! I reached out to my contact at Fan-Tastic Vent and found that your solution is to use the Fan-Tastic Vent 7350 Series Upgrade Kit #FV807359. Your model 6500 is an older version which is no longer in production.…

view full answer...

Answer 6

Yes, the Fan-Tastic Vent 3350 Series Upgrade Kit #FV803358 can be used to upgrade your Fan-Tastic Vent Roof Vent #FV802250. Your current model is just a basic model and the upgrade kit gives you the automatic lift with 3-Speeds, reverse directions, a…

view full answer...

Answer 7

Sounds like you are looking for the part #FV801200. This is a very similar roof vent to the part #FV803350 you referenced at a lower price point that does not have the thermostatic features. I attached a review video for this vent for you to check…

view full answer...

Answer 8

We have a very similar Fan-Tastic roof vent to the #FV801250 that does have a rain sensor, but this one does not. Since this is a manual lift lid there'd be no way to automatically close the lid if rain was sensed. So instead you'd want the…

view full answer...

Answer 9

An upgrade kit simply makes the lid a powered lift, so it won't work no, you'll need to replace your Fan-Tastic Vent fan, which you can do with the following: - Fan-Tastic Vent Roof Vent w/ 12V Fan and Thermostat #FV803350

view full answer...

Answer 10

You definitely can cut the SumoSprings Trailer Helper Springs #TSS-107-40 to fit your application if you don't have enough room. We have confirmed this with SuperSprings on multiple occasions. You might also want to make sure that you haven't…

view full answer...

Answer 11

According to the folks in the engineering department at SuperSprings, the manufacturer of SumoSprings it is acceptable to cut down the SumoSprings if necessary, but be aware that doing so will void the product warranty. SuperSprings recommends…

view full answer...

Answer 12

Yes, I confirmed with Yakima that the expansion kit part #Y02446 does fit your earlier version of the Holdup #02433.

view full answer...

Circuit Board Replacement Solution for Fan-Tastic Roof Vent 2000

Product Page this Question was Asked From

Continue Researching