Which Tripod 5th Wheel Stabilizer Can be Used with an Andersen Ultimate Connection Adapter

Question

Question:

Will this tripod stand accept a ball for Anderson Hitch setup?

asked by: Doris M

0

Expert Reply:

To use a tripod stabilizer with an Andersen Ultimate fifth wheel adapter you'll need to use the replacement ball assembly part # UF19-001057 with an Ultra Fab stabilizer like the part # UF19-950500.

There isn't a way to use the Husky tripod with the Andersen Ultimate.

expert reply by: Jameson C

0

Answer 1

The Ultra-Fab Economy 5th Wheel King Pin Tripod Stabilizer - Steel - 31" to 54" - 5,000 lbs #UF19-950500 will not fit with the attachment for your Andersen Ultimate in place. However, if you want to keep that hitch attachment in…

view full answer...

Answer 2

The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice.…

view full answer...

Answer 3

I recommend to replace the shower faucet in the Jayco with LaSalle Bristol Utopia RV Shower Valve part #34420354RP21. This faucet is designed with a vacuum breaker to allow you to attach handheld shower set part #34423H2485P. The faucet portion of…

view full answer...

Answer 4

Yes, the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger #PD9245C will make a great replacement for your Triad TU-740-2 Converter Charger.

view full answer...

Answer 5

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 6

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 7

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Which Tripod 5th Wheel Stabilizer Can be Used with an Andersen Ultimate Connection Adapter

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching