Replacement Brake Pads for Kodiak 7,000 Pound Disc Brake Kit

Question

Question:

I have this setup on my fifth wheel and I am looking for replacement brake pads

asked by: Jason

0

Expert Reply:

To replace just the brake pads for your Kodiak Disc Brake Kit # K2HR712E I recommend the Kodiak Brake Pads # K250CP-SS. These will work perfectly on your existing assemblies and the stainless steel backing plates will resist any corrosion over time.

I have attached a short video review that you can check out as well.

expert reply by: Chris R

0

Answer 1

Parts #K250CP-SS and #K250CP are both two sets of pads, each enough to re-fit the two disc brake assemblies on one axle.

view full answer...

Answer 2

For your 2014 DRV Mobile Suites, you can use the Kodiak Ceramic Brake Pads #K250CP. These brake pads will work for calipers rated 7,000-8,000-lbs.

view full answer...

Answer 3

The Kodiak Ceramic Brake Pads - 7,000 lbs to 8,000 lbs #K250CP in some ways is rated for the 8,000 lb axle braking. So it will give you braking on 3 axles rated for 8,000 lbs when you use 3 kits. These brake pads are not easy to specify dimensions,…

view full answer...

Answer 4

The appropriate replacement brake pads for the Kodiak Disc Brake Kit #K2HR79E with the Kodiak 250 calipers are the Kodiak Ceramic Brake Pads for 7000-lb brakes #K250CP , which are designed for the 13" rotors in the #K2HR79E kit. There is also a…

view full answer...

Answer 5

For your 2007 Teton Homes Experience, I recommend the Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - Dacromet - 7,000 lbs #K2HR712D for the entire disc brake kit. For just the hub assemblies with rotors, I recommend the Kodiak 13" Hub…

view full answer...

Answer 6

The Kodiak Ceramic Brake Pads, #K250CP or #K250CP-SS, that you referenced can both be used to replace your current brake pads on your trailer's axles. The difference between the two is the #K250CP-SS disc brake pads have stainless steel backs.…

view full answer...

Answer 7

In order to get the correct replacement seal you will want to remove the seal from your hub and get the number stamped on it. If you can't find the number you can also use the dimensions of your seal to get the correct replacement. Get the outer…

view full answer...

Answer 8

The H78-15ST tire size is the same as the 225/75-15 tire size like the part #TTWSF22515D that you referenced. I would recommend the radial version of this tire #TTWTRTM2257515D over the one you referenced as it is a bias ply. Radial tires run cooler…

view full answer...

Answer 9

The difference between load ranges varies based on the tire size and brand. When comparing two tires of the same size and brand, a load range D tire will always have a greater weight capacity and psi rating than a load range C. However, when…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Replacement Brake Pads for Kodiak 7,000 Pound Disc Brake Kit

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching