What Type Of Grease Should Be Used With the Roadmaster Anti-Sway Bar Bushings RM205222-10

Question

Question:

what type of lube should i use when installing these bushings thanx

asked by: Ernie

0

Expert Reply:

When installing the Roadmaster Split Bushing for Anti-Sway Bar part # RM205222-10, I recommend using the LubriMatic Marine Trailer Wheel Bearing Grease part # L154FR. This is the same type of aqualube grease that comes with the kits from Roadamster.

expert reply by: Conner L

0

Answer 1

I checked with Roadmaster, and there are a couple of different bushings, depending on what you needed, for the Roadmaster Front Anti-Sway Bar and TruTrac Rod Kit #RM-1259-106. The correct replacements are the following: - Roadmaster Split Bushing…

view full answer...

Answer 2

Assuming that you're needing the steel U-clamp and replacement bushing for a Roadmaster #RM-1259-105 front anti-sway bar installed on your motorhome built on a 2003 Workhorse W22 Chassis, the replacement U-strap is part #RM-B141 and the…

view full answer...

Answer 3

It sounds like you're looking for the Replacement Bushing for Roadmaster Front Anti-Sway Bar for Motor Homes - Qty 1 #RM-205393-00, which you'll need 8 of. For the bushings that fit around the bar you'll need the Roadmaster…

view full answer...

Answer 4

The Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class C Motor Homes #RM-RBK24-RSSC is the correct fit for your 2006 Ford E-350 with V10. The class B versus class C aspect doesn't change the fit. The frame and motor…

view full answer...

Answer 5

The LubriMatic Marine Trailer Wheel Bearing Grease #L54FR would easily be enough grease for your 6 hub assemblies plus some extra for the future. You are correct though. Pack the bearing by hand and then use the EZ lube fitting to fill it the rest…

view full answer...

Answer 6

The LubriMatic Marine Trailer Wheel Bearing Grease part #L54FR has a calcium sulfonate base. If the Mallory Marine Wheel Bearing Grease part 9-82750 that you are referring to also has this type of base then it will work well together. It will also…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

What Type Of Grease Should Be Used With the Roadmaster Anti-Sway Bar Bushings RM205222-10

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching