Does Timbren Suspension Enhancement System Change Ride Height of 1998 Chevy Express Van

Question

Question:

Will Timbren Enhancement System TGMRG25C Change Height

asked by: Greg

0

Expert Reply:

Because the use of the Timbren Rear Suspension Enhancement System does not affect the empty ride height of the vehicle, you would be able to see no differences between a before and after installation photo. Once the vehicle is loaded to a certain point, the rubber springs that take the place of the factory bump stops will contact the axle and keep the vehicle from sagging further. The system greatly improves ride quality of loaded vehicles, and also helps reduce body roll that is felt during turns.

I have linked you to the install details.

expert reply by: Mike L

0

Answer 1

Other than the Derale #D13503 being slightly larger than the #D13502, there's no difference between the two. Both heat exchangers operate on the same principle, but because the #D13503 has a slightly larger surface area, the #D13503 would do…

view full answer...

Answer 2

Some trailer brake controllers, including many factory-installed models, will not work with an electric-over-hydraulic type trailer brake actuator like the Hydrastar #HBA16. EOH actuators like this present a very different electrical load to the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Yes we do have a set of Timbrens that fit your 2024 Toyota Tundra with the part #T45MR. These can give you up to an additional 6,000 lbs of suspension support.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

You can install a stack cooler in your vehicle. The Class ratings are there as a reference point to a hitch Class. For example if someone has a Class III hitch they can look at coolers, see a Class III and say, hey, I have a Class III hitch so this…

view full answer...