Is the Titan Brake Kit Compatible with Actuator on 1994 EZ Loader Tandem Axle Boat Trailer

Question

Question:

would the T4843500 disc brake kit be compatible with the disc brake acuator on a 1994 EZ laoder tandum axle boat trailer and if so can I buy the kit minus the acuator.

asked by: Doug H

0

Expert Reply:

Since the actuator you currently have is compatible with disc brakes, it should work fine with the Titan disc brakes as long as the actuator is in good repair. Make sure the existing actuator has a 1500 psi rating and that the bearing and seal numbers listed for the rotors are compatible with your existing bearings. In order for the kit to work for you, your axle will need the standard 4 bolt mounting flange for the calipers to attach to.

You might also need the line kit, part # T4829900 if your existing lines need replacement.

expert reply by: Mike L

0

Answer 1

When looking for a replacement brake line kit, you will want to measure from the port on the back of the actuator to the T-Fitting where the lines split off and go to the separate brakes, which is typically right at the axle. There will be a short…

view full answer...

Answer 2

It sounds like you are looking for a Titan Model 10 or 20 master cylinder replacement based on what you listed which we offer with part #T2374400.

view full answer...

Answer 3

If your Dico Actuator is a model 10 or 20 and is designed for disc brakes then part #T4749501042 will work well for you. If you have drum brakes, and have model 10 or 20, then the replacement master cylinder you need is part #T2374600.

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 7

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 8

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Is the Titan Brake Kit Compatible with Actuator on 1994 EZ Loader Tandem Axle Boat Trailer

Product Page this Question was Asked From

Continue Researching