Does Valterra Window Frame for RV Entry Doors Require Sealant

Question

Question:

12X21 door window frame gasket or sealer options? what do you recommend for weather sealer or gasket not mentioned!

asked by: Jerry M

0

Expert Reply:

When installing the Valterra Replacement Window Frame for RV Entry Doors - Exterior # A77008 and Interior # A77012 with Mounting Screws for Valterra Entry Door Window Frames - Black - Qty 100 # A77048 I recommend using TremPro 644 Silicone Sealant # 0160297.

You can use the same for the Valterra Frame Assembly and Glass for RV Entrance Door - 12" x 21" # A77051 which is assembled and has the glass along with mounting screws.

expert reply by: Kyle S

0

Answer 1

The screws part #A7704812 for the Valterra Replacement Window Frame #A77012 are sold separately.

view full answer...

Answer 2

We may have what you're looking for, for your 2014 Livin Lite Quciksilver, however to be certain I would need to know the size of window you're replacing. For instance, we have the: -Replacement RV Entrance Door Glass #VAL58GR which…

view full answer...

Answer 3

The part #A77012 is just the interior piece. For the exterior piece you'd also want the part #A77013 to go along with it.

view full answer...

Answer 4

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 5

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Does Valterra Window Frame for RV Entry Doors Require Sealant

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching