Washer Recommendation for Trailer Spindle that has Flat Tab That Matches Spindle Surface

Question

Question:

The axel on my trailer has a washer with a tab bent out of it to hold the nut on instead of a charter key hole and I’m trying to find the replacement kit for it how do I go about it I can’t find any numbers or anything on it

asked by: Terrance

0

Expert Reply:

Sounds like your spindle has a tang washer like the part # 5-101 based on what you described. This is a very common washer setup for trailer axles. I attached a picture that shows what it looks like installed as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Dexter trailer axle #84545UC1-EZ that you mentioned is sold individually. If you needed two you would need to order a quantity of two.

view full answer...

Answer 2

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

view full answer...

Answer 3

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

view full answer...

Answer 4

I recommend the Dexter Trailer Idler Hub Assembly for 2,000-lb Axles, #8-258BTUC1 with a 5 on 4-1/2 bolt pattern and wheel size of 13" to 15".

view full answer...

Answer 5

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 6

Since you have a 4 on 4 inch bolt pattern currently that would indicate that you have a 2,000 lb axle so you could swap your current hubs pretty easily with the bolt pattern you are looking for with the part #34822545BX that you referenced. This hub…

view full answer...

Answer 7

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…

view full answer...

Answer 8

The Dexter Trailer Hub Assembly you referenced, part #AKIHUB-440-2-1K is known as an idler hub. An idler is a hub that is no provisions for trailer brakes. It has no brake drum. Part #8-276-5 is an example of a hub/ drum that has a brake drum that…

view full answer...

Answer 9

Yes, the CE Smith Trailer Hub part #CE13511 will fit as a replacement for your DICO hub 45264 but you will need to use a different seal as we have found that your spindle diameter is slightly different which means you need the #168255TB as well.

view full answer...

Answer 10

The only repair kit we have for your Profile 2000 hand winch is the Winch Ratchet Repair Kit by Dutton-Lainson item #DL70475. If this isn't what you are needing you will have to replace your winch. I recommend the Dutton-Lainson Hand Winch -…

view full answer...

Washer Recommendation for Trailer Spindle that has Flat Tab That Matches Spindle Surface

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching