Replacement Hinges for Furrion Stove Top with Glass Folding Cover

Question

Question:

I need to purchase new hinges for the glass top on our stove, are they available? This is on a new trailer, I bent the glass backwards and bent the hinges.

asked by: Allen L

0

Expert Reply:

I reached out to my contact at Lippert and was able to get the hinges you are seeking for your Furrion glass cover. The Replacement Hinges for Furrion 2-in-1 Range Oven - Qty 2 # LC719851 are what you need.

expert reply by: Jason S

0

Answer 1

The replacement glass cover for your Furrion 2-in-1 Range Oven is part #C-FSRE21SA-SS-003. This is compatible with the 17" ovens #FSRE17SABL and #FSRE17SASS as well as the 21" oven #FSRE21SABL.

view full answer...

Answer 2

While we do not have a direct replacement for your Magic Chef, the: -Replacement Stainless Steel Top with Glass Cover for Furrion 2-in-1 Range Oven #C-FSRE21SA-SS-003, May work out great for you, and has really similar dimensions as your Magic Chef…

view full answer...

Answer 3

Accidents happen to the best of us on occasion, so we do have a replacement top for you. It looks like you have the Furrion 2-in-1 Range Oven with Glass Cover FSRE17SASS, though just the front piece of the glass top by itself is not available as a…

view full answer...

Answer 4

As far as the dimensions for the Furrion Replacement Stainless Steel Top #C-FSRE21SA-SS-003, it measures 19-3/16 inches long x 21-3/8 inches wide x 2-1/4 inches high. I went ahead and diagrammed these dimensions and attached them to this answer.

view full answer...

Answer 5

Pin box bolt torque is based on the size of the bolts. 1/2 inch Bolts GR5 90 ft-lbs 5/8 inch Bolts GR5 150 ft-lbs 3/4 inch Bolts GR5 275 ft-lbs

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 10

The first thing you will need for your 1999 D250 is a 4-way. The Curt T-Connector Vehicle Wiring Harness #C55317 plugs into the connection points behind your rear bumper and will allow you to power your trailer's signal lights. Once the 4-way is…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Replacement Hinges for Furrion Stove Top with Glass Folding Cover

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching