Will the Yakima FullBack Fit a 2017 Audi Q7

Question

Question:

Thanks and Is there one for three bikes?

asked by: Marie D

0

Expert Reply:

Yes, the Yakima FullBack 2 Bike Rack part # Y02634 is a fit for your 2017 Audi Q7 and an excellent choice at that. I have attached the fit notes for you on this rack as well as a few install photos. Please note that if any of your bikes have an alternative frame you will also need to use the Yakima Tube Top Bike Adapter Bar part # Y02531.

- Outer/lower support frame rests on the lower portion of the license plate or well. When bikes are loaded, re-tension straps to ensure base pads only make contact with the vertical surface of the well or plate.
- Do not use rear wiper when carrier is installed.
- For this vehicle; Yakima Halfback, Fullback, and Hangout products require that the upper and lower hooks must be changed and installed in anchor mode. See instructions for anchor mode implementation.

expert reply by: Conner L

0

click to enlarge

Marie

5/25/2019

Thanks and Is there one for three bikes?

Reply

Conner L.

5/25/2019

Yes, the Yakima FullBack 3 Bike Rack part # Y02633 will also fit and it holds three bikes.

Reply

Answer 1

Let me begin by saying that anytime you have a piece of equipment strapped to the painted finish of a vehicle, the potential for scratches or dents exists, no getting around it. This being said, the risks can be minimized by putting as little…

view full answer...

Answer 2

Yakima has the Fullback part #Y02634 as a confirmed fit for your 2018 Toyota Prius and they state to put the straps in anchor mode for the top straps. I attached a picture of what the straps look like in this setting. This is essentially the…

view full answer...

Answer 3

When in anchor mode, you do not need to pull them so they're flush to the hatch internals. I have included a picture to illustrate and also an install video of the Yakima FullBack #Y02634 if you haven't taken a look already!

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

I'll start off with the ski rack for your 2024 Jeep Grand Cherokee Laredo since that is fairly simple. I recommend the Rhino-Rack Ski and Snowboard Carrier #RR574. This is capable of holding 4 pairs of skis, has an aluminum construction for…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Thanks for reaching out to verify, Frank! Yes, those parts (listed below) will fit great together and on your 2010 Honda Accord Crosstour with the naked roof. Inno Roof Rack - Aero Crossbars #INXB130-138 - Through Feet #INXS250 - Fit Kit #INK587…

view full answer...

Answer 8

Hey Antone, you are right the battery placement on the 2022 Honda CR-V is the reason the hitches do not fit so a trunk mounted bike rack solution would be your best bet. The one I recommend for your CR-V is the Saris Bones 2 part #SA805BL that you…

view full answer...

Answer 9

For your 2024 Toyota Sienna XSE I recommend the etrailer Trailer Hitch Receiver #e56RR. This features a 2" receiver with a bolt-on installation. It has a 350 lb max tongue weight which should be more than enough for your bike rack and bikes.…

view full answer...

Answer 10

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 11

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack…

view full answer...

Answer 12

The Kuat Sherpa 2.0 #SH22G and the NV 2.0 #NV22G that you referenced are both excellent platform-style racks that will hold your bikes by the front wheels with no frame contact. These are top-of-the-line carriers and you really would not go wrong…

view full answer...

Will the Yakima FullBack Fit a 2017 Audi Q7

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching