Brophy Camper Hold Down Recommendation for a 2004 Chevy 2500 HD with an 8 ft Slide-In Camper

Question

Question:

What is the best way to tie down a 8ft slide in camper to my short box 2500?

asked by: Eric R

0

Expert Reply:

The Brophy Camper Hold Downs, item # HSSF, should fit on your 2004 Chevrolet Silverado 2500HD to secure your 8 foot slide in camper. This is one of the best ways to secure campers in the bed of a truck. If you check out the product reviews you can see that many customers are very satisfied with this product.

expert reply by: Jameson C

0

Answer 1

Yes, the Brophy camper tie downs part #HSSF that you referenced can fit truck bed that have plastic bed rail covers like your 2020 Chevy Silverado 2500. I attached a picture that shows them installed on a bed rail that has the covers like you…

view full answer...

Answer 2

There is no weight capacity for the Brophy Clamp On Camper Tie-Downs #HSSF. The tie-down hardware kit #TDHP, that is used to secure the camper to the #HSSF tie-downs has a weight capacity of 3,000-lbs. My contact at Brophy said the tie-downs will…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 5

Hey Robert, sorry it can be a bit confusing navigating all those facets for the camper tie downs, but I did go ahead and find those tie downs you were looking for. For the front, you'll want the TorkLift Camper Tie-Downs #TL87CR (TorkLift P/N…

view full answer...

Answer 6

Unfortunately we do not have a way to replace the keys without knowing the key number for the lock. If they happened to have written down the key number from the lock then we will be able to get you a replacement. The etrailer Trailer Hitch Receiver…

view full answer...

Answer 7

Of the two part numbers you mentioned only the #TLF2022A is a fit for your 2022 Ford F-350 short bed without factory board and with the factory installed hitch. You might have meant to type #TLF2022 which is the non-aluminum/stainless steel option…

view full answer...

Answer 8

The current Torklift tie down part #TLD3101 that you have installed on your 1997 Dodge Ram 3500 only fits if you have the factory hitch. If you go with the SuperHitch part #TLD1100 you would need to change your rear tie down to the part #TLR3503.

view full answer...

Answer 9

The F2032 you're looking for is under part #TL87CR on our website and would be the correct fit for your 2024 Ford F-350. For the rear tie-downs you'll need part #TLF3008. To complete the setup you can use the TorkLift AnchorGuard Derringer…

view full answer...

Brophy Camper Hold Down Recommendation for a 2004 Chevy 2500 HD with an 8 ft Slide-In Camper

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching