How to Remove Trim Pieces From Jensen RV Stereo # JWM60A

Question

Question:

How do you get the trim piece off. Dont want to break them.

asked by: Greg E

0

Expert Reply:

On the side of the Jensen RV Stereo # JWM60A there is a small recessed section that you will use to safely remove the trim pieces. You can use a flat head screwdriver to gently pry the trim panel away from the unit at this location. I have attached an image to assist.

I have also attached an installation video that you can reference. If you skip ahead to the 8:20 mark you can see the installer remove the trim panels.

expert reply by: Chris R

0

click to enlarge

Answer 1

The JWM62A actually replaced the #JWM60A and we decided to keep the old part number on our site. So if you ordered a #DV1230BL you'd actually get the current updated version JWM62A.

view full answer...

Answer 2

The Jensen RV Stereo #JWM60A that you referenced is actually a very popular option with our customers to replace the Drive EEDV06. This will definitely provide you with an upgraded system both in function and reliability and because it features a…

view full answer...

Answer 3

The Jensen RV Stereo AWM965 is not Bluetooth compatible nor am I aware of any adapter that would give the device this feature. Therefore, the best option would be to upgrade with the Jensen RV Stereo part #JWM60A. The Jensen JWM60A like the Jensen…

view full answer...

Answer 4

The Jensen Stereo -AM/FM - CD/DVD - USB - Bluetooth #JWM60A has locations on the two sides that are removable to access the mounting holes. I went out to our warehouse to confirm this. They do pry off without breaking if you are patient and take it…

view full answer...

Answer 5

What you sent in your picture is the heat sink and is normal to get hot as it is designed to dissipate heat so there's no concern there. If you are hearing static through the speakers that most likely means your antenna isn't…

view full answer...

Answer 6

ince the Jensen VR187 is a 1.8 DIN stereo system you will have to make alterations to the cutout hole to fit any replacement. I recommend upgrading to the Jensen RV Stereo #JWM45. This Double-DIN stereo plays audio from radio signals, CDs, DVDs, and…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

The correct rail kit you need for your Demco Hijacker Autoslide part #DM8550040 to fit your 2016 Ford F-350 is the part #DM8552000-71.

view full answer...

Answer 12

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

How to Remove Trim Pieces From Jensen RV Stereo # JWM60A

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching