How to Use A Portable Heater in My ATV

Question

Question:

Do you have a dependable heater that will take off a.m. chill in my side by side cub cadet without any mounting or battery drainage problems.i have front and rear windows but no door windows.

asked by: Christine C

0

Expert Reply:

We have had great reviews for the Rampage Radiant Backseat Heater part # RA3501. It uses a 12V power source so you can wire it directly to the battery of the Cub Cadet. As long as you are using it while the ATV is started it should not drain the battery. If you leave the heater on while the ATV's engine is not running then it can drain the battery.

You can wire the heater to its own 12V battery and use a trickle charger part # CTEK56353 to maintain the battery's charge. I am not sure if you have a backseat in the Cub Cadet but you may be able to bolt the provided pre-drilled mounting bracket to the passenger side floor board. It is not a good idea to use the heater when you have a passenger though. It is not a big heater so you should be able to find space for it, the heater measures 8 inches tall by 7 inches wide and 6 inches deep.

expert reply by: Heather A

0

Answer 1

The Round, Pipe Mount Swivel Jack #TJP-5001S-B uses a 5/8" Diameter Pull Pin #TJP-PN58. The jack slides onto a 2" diameter weld on pipe that is included.

view full answer...

Answer 2

The Triple-Axle Trailer Hanger Kit #APTT3 that you referenced is designed to work on axles with capacities of 2,000 lbs to 7,000 lbs so it should work very well for you. I attached a picture that has a chart that shows exactly how you should space…

view full answer...

Answer 3

Yes, the Replacement Cab End Corner and Weather Seal Kit for TruXedo TruXport Tonneau Covers #TX1118262 would be a compatible fit for your cover. If you need to replace the rear caps as well then you'll need part #TX1704534, #TX1704535 , and…

view full answer...

Answer 4

In the image with the suspension setup the equalizer #TREQ105 is placed between the front and second axles. Just like you have on your trailer. The front of the equalizer connects to the spring using a shackle strap and the rear is connected directly…

view full answer...

Answer 5

You are correct the HappiJac Camper Tie-Downs #LC182904-182971 are the correct kit for your 2013 GMC Sierra 3500 with a regular cab and 8' bed. I would highly recommend looking at the Torklift Front #TLC2215 and Rear #TLC3212 as a better option…

view full answer...

Answer 6

The Brophy Clamp On Camper Tie-Downs #HSSF will have a very slight amount of play since there is a compressible pad to prevent scratches on the bedrails, but it sounds like you're having much more significant play. I've attached a picture…

view full answer...

Answer 7

Hey there Gary, thanks for the photo and yes the etrailer Bolt-On Swivel Mounting Plate for 3,500-lb Trailer Jacks with a 5/8" Swivel Pin #e52JR will indeed work with your Round, Pipe Mount Swivel Jack #TJP-5001S-B.

view full answer...

How to Use A Portable Heater in My ATV

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching