Will Solera 12 Volt Awning Upgrade Fit 2008 Tiffin 34TGA

Question

Question:

Has this been installed on a 2008 Tiffin 34TGA?

asked by: John

0

Expert Reply:

We haven't personally installed the Solera 12V Power RV Awning Conversion Kit # LC434723 on a 2008 Tiffin 34TGA but regardless of what you have installed on your RV now this will fit and work well as an upgrade since this is designed to replace all of the standard RV brands like Dometic and Carefree.

I attached a review video for this kit for you to check out as well.

expert reply by: Jameson C

0

Answer 1

To convert your Dometic manual awning to a power unit, you can use the Solera 12V Conversion Kit in Black #LC434723 or White #LC434724 if you have a manual crank system. These Solera kits are compatible with Dometic (A&E) awnings like what you…

view full answer...

Answer 2

I was able to go out to the warehouse and measure the diameter of the end caps for the Solera Manual Pull Style to Power Awning Conversion Kit #LC329251 that you reference. The inside diameter is 3-1/2" The outside diameter is 3-5/8" This…

view full answer...

Answer 3

The diameter of the end cap of the Solera 12V Power RV Awning Conversion Kit - Black #LC434723 as well as White #LC434724 is 3-5/8 inches in diameter. I have added links to video reviews for you to check out as well.

view full answer...

Answer 4

Yes, a 20 foot wide Dometic A&E awning is compatible with the conversion kit with 69 inch arms; specifically, the Solera conversion kit is compatible with Dometic A&E awnings that have an 8 foot extension, and are models 8500, 9000, or 9100.…

view full answer...

Answer 5

The Solera 12V Power RV Awning Conversion Kit - Universal - 69" Arms - Black #LC434723 comes with everything you need aside from the roller and fabric you already have. This kit is compatible with your existing Lippert awning and will work well…

view full answer...

Answer 6

If I were you and I was having trouble with water damaging the exterior touch pad, I would first take some silicone sealant like part #LT37467 and seal up the arms as best you can at any place water could enter. If this did not work then the only…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

For your 2018 Ram 2500 with the factory puck system the best 5th Wheel Hitch is the B&W OEM Companion. If you have the 8 foot bed then you will want the fixed 25K #BWRVK3600 and if you have the short 6-1/2 foot bed you will need the 20K Slider…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

When installing an awning like the Solera Smart Arm 12V Power RV Awning #LC517486, the arms will be secured to the wall framing. When the awning extends there will be quite a bit of leverage, so it is important to mount the awning to an area where…

view full answer...

Answer 11

To get power to the controller of your Solera Smart Arm 12V Power RV Awning part #LC759404, you need to tap into an existing circuit, or run a power wire from the battery with an inline fuse holder, and a 15 amp fuse, like part #SWC9538, and part…

view full answer...

Answer 12

Brien, it sounds like you did your research so kudos to you, but the awning you're looking at is not going to work with the wind sensor. You'd need to use the Solera Smart Arm 12V Power RV Awning #LC517517 instead. You're also going to…

view full answer...