Can RoadActive Suspension Fit Truck with Lift Kit

Question

Question:

Can these be used on a truck with a suspension lift

asked by: David C

0

Expert Reply:

As long as the leaf springs of your truck are the same the RoadActive Suspension # RAS3611-Y will still fit. If the spring changed it's hard to say for certain what RAS kit would fit it since it would not have ever been tested.

expert reply by: Jameson C

0

Answer 1

I reached out to my contact at RoadActive Suspension and they verified that with your 2017 Ford F-150 unloaded the RoadActive Suspension Kit #RAS3611-Y may give you anywhere between 1/4" to 1" of height. Depending on how the truck is…

view full answer...

Answer 2

The main difference between the RoadActive Suspension #RAS54FR and #RAS4611, will be the weight capacities. Both of these will install and function the exact same way, but the #RAS54FR will have a maximum capacity of 3,000 pounds and should be used…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

The Air Lift WirelessONE Compressor System #AL25980EZ and Air Lift WirelessONE Compressor System #AL25980 are nearly identical with only some very minor differences in CFM and duty cycle ratings. The #AL25980EZ will also come with an easier mounting…

view full answer...

Answer 11

Hey Deanna, the brake controller I recommend for your 2005 Toyota Tundra is the Redarc Tow Pro Liberty part #RED24FR as it only puts a small knob on the dash of your truck and uses an inertia sensor to determine how hard you are hitting the brakes…

view full answer...

Answer 12

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...