Which is Front and Rear Mud Flap of WeatherTech Mud Flaps # WT110024-120024

Question

Question:

Does the larger mudflap go in the front or back

asked by: Cristina

0

Expert Reply:

For the WeatherTech Mud Flaps # WT110024-120024 that you referenced the front set is the set that's a bit wider than the rear set.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The usable length of the etrailer Pull Pin #TJP-PN916 is 3-1/2" with 3-1/8" to the center of the detent ball, as show in the attached photo. This pin is designed for use with etrailer and Ram Pipe Mount Swivel Jacks 9/16" Diameter.

view full answer...

Answer 5

We carry rims with a 4.75 pilot hole, like #LHHA420, and #AM20783, however they're both for dual wheel applications and have an offset. Using a wheel with a 4.75 or 4.77 pilot will be just fine since there's such a small difference. It's…

view full answer...

Answer 6

The base or bezel used by the Bargman #47-84-527 Double LED tailllight is constructed of hard plastic, like the other rectangular lamps of this type. If you click the provided links, you can see a product demonstration and an install video. For…

view full answer...

Answer 7

Hey Roland, good question and the answer is you can leave your 18 inch spare tire on your 2022 Dodge Durango and still install the Draw-Tite Max-Frame Trailer Hitch Receiver #DT38MR.

view full answer...

Answer 8

All of the hitches we offer for your 2020 Dodge Durango like the Draw Tite part #DT38MR do not fit with spare sizes that are larger than 18 inches. Now if what you have truly is smaller in overall diameter than a standard tire size that fits your…

view full answer...

Answer 9

The Draw-Tite Class III Max Frame Receiver Hitch part #DT38MR does require the removal of a 20" spare tire. The hitch is designed to fit with a stowed 18" tire but not 20" so it will not be able to remain stowed under the vehicle.…

view full answer...

Answer 10

It sure will! The Curt T-Connector Vehicle Wiring Harness #C56336 you were looking at is compatible with your 2021 Dodge Durango with LED tail lights. I included a video of the #C56336 being installed for you to take a look at.

view full answer...

Answer 11

The Curt T-Connector Vehicle Wiring Harness #C56336 that you referenced is designed for your 2018 Dodge Durango if it did not come with the factory tow package, but it can certainly still be installed and used on your Durango if it does have the…

view full answer...

Answer 12

It is required to run a power wire from the Curt T-Connector Vehicle Wiring Harness part #C56336 to the battery on a 2019 Dodge Durango. The power wire is actually what provides power to the lights on the trailer. The tee connectors simply obtain the…

view full answer...