Replacement L44549 Bearing for Coleman Pop Up Camper

Question

Question:

Hello, this is my third time attempting to send this. I’m looking to replace the bearings,etc on my 1995 Coleman Cedar pop up. I believe the bearing I need is an L44549 however it’s add an L44649 to my cart. Which one is the correct one? I added a picture.

asked by: Kris K

0

Expert Reply:

I'm not able to find any information on an L44549 bearing so it's very likely that what you have is actually the # L44649 bearing. We have actually seen this before where the 6 on the number gets worn a bit so that it looks like a 5 when it's taking out of the hub.

To be sure you can also measure the inside diameter of your bearing. If you get an inside diameter of 1.063 inches then you know it's the # L44649.

Unfortunately the picture you mentioned did not come through but if you can email it to me separately I will be happy to take a look.

expert reply by: Chris R

0

Answer 1

I was able to locate the correct bearings, races and seal that correspond to the part numbers you provided in your question. For bearings you will need the part #L44649 and for races you will want #L44610. Then for the grease seal you will use part…

view full answer...

Answer 2

From the numbers you provided it sounds like you need replacement grease seals. In my research, the grease seals I found with the GS-1719DL number have a 1.72 inside diameter and 2.565 outside diameter. The replacement double lip grease seals you…

view full answer...

Answer 3

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 4

Yes, the Timken Bearing Kit #TMK52VR will fit your 3,500 lb axle as it fits an standard #84 spindle. The only time this kit won't fit with a 3,500 lb axle is if the trailer/axle is made before the 2000's since that's about the time that…

view full answer...

Answer 5

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 6

The Dexter bearing kit part number K71-717-00 that you referenced is the bearing kit for a number 84 spindle. Our part number for that bearing kit is #BK2-100.

view full answer...

Answer 7

Depending on how the trailer was made, there will be a few spots you can check to identify the axle. First, if the trailer was pre-made by a specific company, you may be able to find this information in either the paperwork or on a placard somewhere…

view full answer...

Answer 8

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the 1-1/2" Square…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement L44549 Bearing for Coleman Pop Up Camper

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching