Are Load Resistors Needed for Switching Travel Trailer 1156 Bulbs to LED Versions
Question:
Will the LED bulbs replace 1156 bulbs used for Travel Trailer Rear Brake, Turn signal and license plate light and do I need the resistor kit?
asked by: Phillip B
Expert Reply:
The LED versions of light bulbs such as those that replace the popular 1156 type generally do not require load resistors. All of the LED elements that fit in place of an 1156 bulb are shown on the linked page and these include the 18-LED bright white part # DI85VR, as an example.
Some trailers and vehicles may need load resistors when they are switched to LED lights but this can't be predicted 100% of the time. There are a lot of variables in wiring setups. Most often the LED replacements will work just fine. But if the turn signals exhibit fast hyper-flashing load resistors like # DI34ZR can be installed.
Please note that your lights will be brightest if you match the color of the LED light to the color of the light lens it will shine through. For example, if you were installing an LED light behind a red lens you would want to use a red LED such as # 11562-S21SMD-R.
Products Referenced in This Question
Luma LED Bulbs - 1156 - 360 Degree - 42 Diodes - Red - Qty 2
- Vehicle Lights
- Interior Light
- Marker Light
- Tail Light
- Brake Light
- Reverse Light
- Turn Signal
- Pair of Lights
- LED Light
- Replacement Bulb
- 1156
- Red
- Luma LEDs
more information >
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
1141/1156 LED Bulb - Single Contact Bayonet - 360 Degree - 210 Lumens - Cool White - Qty 2
- Vehicle Lights
- Interior Light
- Marker Light
- Dome Light
- Side Marker
- Pair of Lights
- LED Light
- Replacement Bulb
- 1141
- 1156
- White
- Diamond
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Box with Non-LED Lid for Engager Breakaway Kit
- Q&A: Do I Need a Load Resistor With the Bargman LED Triple Tail Light
- Search Results: bargman 84 series led
- Search Results: water heaters
- Shop: Replacement Battery Box for Dexter Gel Cell Breakaway Kit
- Video: Titan Trailer Breakaway Kit TN65117 Review
- Search Results: atwood water heater
- Shop: LED Combination Tail Light for Trailers over 80" Wide - Submersible - Red - Passenger Side
- Shop: LED Combination Trailer Tail Light - 6 Function - Submersible - 12 Diodes - Passenger Side
- Shop: LED Trailer Tail Light - 6 Function - Submersible - 18 Diodes - Rectangle - Red Lens - Passenger
- Shop: Replacement Battery Box for Breakaway Kit
- Shop: Grease Seals 10-36 (pair)
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Shop: Trailer Hitch
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Search Results: 25580
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Shop: Fifth Wheel Hitch
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Search Results: 68149
- Article: How to Choose the Right Trailer Hitch Class
- Video: Titan Trailer Brakes T2385200 Review
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: Brake Controller
- Search Results: dust cap