Is Gustafson RV Puck Light # 277-000341 Dimmable

Question

Question:

Is this light dimmable?

asked by: Charlie

1

Helpful Expert Reply:

The Gustafson RV Puck Light # 277-000341 is a dimmable LED Light when used with a compatible dimmer switch. We don't carry the dimmer switch, but according to my contact at Gustafson it will be compatible. They said the switch will dictate how well it dims.

expert reply by: Jameson C

1

Answer 1

We have puck lights like the Command Electronics part #328-K-1050Q9 which is 4-1/2 inches in diameter but since I was not able to find any info on the part number you mentioned I would need dimensions from you if you needed a different size puck…

view full answer...

Answer 2

I wasn't able to find any model information on your Sunlink RSBF3NN-008 and we don't carry that particular brand, but we do have a number of recessed puck lights available that may work for you. You may be able to use the Gustafson RV Puck…

view full answer...

Answer 3

I have a solution for you, but the main issue with puck style lights that mount to the surface of your RV ceiling or under cabinets, is that there aren't replacement bulbs available and they aren't really designed to have the bulbs replaced.…

view full answer...

Answer 4

The Gustafson RV Puck Light #277-000343 can be used with a dimmer switch but the dimmer switch needs to be designed for use with LEDs. Otherwise if you use a non-LED dimmer when you go to dim the lights they might flash and make a weird noise at the…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

I have a solution that may work for you, but we do not currently have any 3" diameter submersible reverse lights. Have a look at the Optronics Backup Light #BU45CB which is a 4-1/4" diameter light that can be mounted to your trailer using…

view full answer...

Answer 7

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

Answer 8

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 9

We carry replacements that could integrate into your Dometic AC system, but before purchasing anything you'll need to remove the cover of your air distribution box under the unit you're wanting to replace and look for the wire harness that…

view full answer...

Answer 10

For the Tecnic 45 degree accent light part #TN42FR the correct mounting cover is the part #TN34FR.

view full answer...

Answer 11

The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To add…

view full answer...

Answer 12

In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along with…

view full answer...

Is Gustafson RV Puck Light # 277-000341 Dimmable

Product Page this Question was Asked From

Continue Researching