Relay Locations for 2017 Nissan Frontier

Question

Question:

having some confusion with your techs explanation of where it should be located on my 2017 frontier? to left of steering column OR behind passenger kick panel? thanks.

asked by: Randy O

0

Expert Reply:

The relays should be located behind the passenger-side kick panel on your 2017 Nissan Frontier, as shown in the accompanying photo.

I have added a link to a video of the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56225 which shows exactly where they would need to be attached.

expert reply by: Kyle S

0

click to enlarge

Answer 1

I've included the link to one of our installation videos on the 2019 Nissan Frontier that uses the Curt #C56225, which comes with the relays included; these relays can also be purchased with the Curt Relay Kit #59700. If you fast forward to…

view full answer...

Answer 2

Trailer running lights not working with certain Nissan vehicles is a common problem with an easy fix. There is a relay for the trailer running light circuit that is located in the fuse box (in the cab). If that relay is missing or no longer functions…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Relay Locations for 2017 Nissan Frontier

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching