Can Demco A-Frame Coupler Replace Ram 5,000 lb A-Frame Coupler

Question

Question:

I have a Ram 5000 lb A-frame coupler on my utility trailer now. Piece of junk. I would like to replace it with a Demco. Cant tell if it will fit...

asked by: Fred M

1

Helpful Expert Reply:

The great thing about a-frame couplers is that they basically all can fit and interchange with each other. You could easily remove the Ram 5000 jack you have on your trailer to replace it with the Demco A-Frame Trailer Coupler # DM14793-81 that you referenced.

expert reply by: Jameson C

1

Answer 1

While we do not carry trailer frames we do carry all the other parts you are going to need to build your tear trailer. I have compiled a list of parts that you can use to build a 3,500lb GVWR Trailer. Trailer Axle with Idler Hubs #e72GR Single-Axle…

view full answer...

Answer 2

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 3

I checked the Featherlite Trailer website for specs on the model 3116 trailer but this part number returned no results. But if your trailer uses an industry-standard 50-degree a-frame design then the Demco A-Frame Trailer Coupler #DM16680-52 will fit…

view full answer...

Answer 4

To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts per…

view full answer...

Answer 5

The play you are feeling/hearing is most likely between the hitch ball and the latch of the coupler. If you look under the coupler you can see an adjustment bolt that uses an Allen wrench that will allow you to tighten the latch and get rid of the…

view full answer...

Answer 6

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 7

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for attaching the…

view full answer...

Answer 8

Yes, you can remove your weld-on coupler and install a new bolt-on coupler that fits a 2 inch ball. There is just a few things you need to do to before and when installing. You need to know what channel size and the weight capacity you will need for…

view full answer...

Answer 9

You are correct. Other than how they are made, the Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K #DM37ZR and the #DM14793-81 have the same ratings and will work the same. There is no pro or con to either, so…

view full answer...

Can Demco A-Frame Coupler Replace Ram 5,000 lb A-Frame Coupler

Product Page this Question was Asked From

Continue Researching