Sunset Sunray 169QB Trailer Cover Recommendation

Question

Question:

Will this fit my 16 foot Sunset Sunray 169QB. Wasnt sure if it would fit due to the rounded contours on the front and back and if that wasnt an issue, would the 15foot work or would I need the 18? Thanks!

asked by: Aaron

0

Expert Reply:

Your trailer is a teardrop style of trailer with the way the front curves. So the cover you would want is the Classic Accessories Deluxe PolyPro III HD Cover for R Pod Trailer - Up to 18' 8" Long # CA80199. This fits the size and shape of your trailer. Check out the install picture I attached to see it installed on a similar style of trailer.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Thank you for the photo. Your JR Products model GR-618 is a single stage, 18 psi, high-pressure regulator that is no longer available. It has been replaced by the JR Products High Pressure RV LP Gas Regulator (model GR-630) #37207-30325, which is a…

view full answer...

Answer 2

We do! The correct part for your Atwood model GC66A10E is the Replacement Circuit Board for Dometic Atwood Water Heaters #DMC89FR. I confirmed this with my contact at Dometic.

view full answer...

Answer 3

I looked up the Sunset Park RV Sun-Lite 16BH and the official length is listed at 16' 6" therefore in order to find the correct cover we'll need to subtract 3' for the tongue and round up which means we're looking at a cover for…

view full answer...

Answer 4

Classic Accessories offers a storage cover made specifically for the Forest River R-Pod 177 teardrop trailers, which measure 18-feet, 8-inches in length from end to end as shown in the linked image. You can use part #CA80199. This cover comes with a…

view full answer...

Answer 5

Your 18ft Forest River Retro camper shares the same body style/shape as the R-Pod campers so the best camper cover we have will be an R-Pod cover designed for an 18 foot length like the Classic Accessories Deluxe PolyPro III HD Cover part #CA80199.…

view full answer...

Answer 6

I looked up the length of your 2018 Littleguy Max and found it to be 17 foot 2 inches and since it's the R-Pod style of tear trailer the cover you'd want is the #CA80199 which will fit really well and provides excellent protection too.

view full answer...

Answer 7

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 8

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be totally perfect…

view full answer...

Answer 9

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 10

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 11

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...