Best Storage Cover for a 2018 Aliner Scout Pop-Up Camper

Question

Question:

we have a 2018 Aliner Scout. we live in NJ northwest NJ near Easton PA we get a fair amount of wind all winter plus rain, snow, sleet, etc. what kind of cover should i be looking for for our Aliner?

asked by: Dave

0

Expert Reply:

Your 2018 Aliner is about 18 foot in length including the front tongue. For that reason I would suggest a 16-foot cover like the ADCO # 290-2894 RV storage cover.

Polypropylene pop-up camper cover works best for short-term storage in all climates. Lightweight fabric protects against moderate sun, dust, and water. Contoured fit conforms to the shape of your camper. Cinch ropes and buckles ensure a secure fit.

expert reply by: Conner L

0

Answer 1

The Camco RV Water Heater Anode Rod part #CAM11563 is what you need for the suburban SW6D water heater.

view full answer...

Answer 2

I have attached for you the wiring part of the install instructions for the Camco Propane to Electricity Converter for 6-Gallon RV Water Heaters part #CAM11673 below.

view full answer...

Answer 3

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 4

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 5

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 9

You can get a new brake mounting flange for your axle. The old flange will need to be cut off. The part is #4-44-1. This is designed to fit a 3 inch trailer axle and should be welded in place by a professional. Since you would also have to get the…

view full answer...

Answer 10

We do carry electric brake assemblies as well as hub/drum assemblies. To determine the correct fit, you will need to measure the spindles of your axles. I've attached a photo to assist with the measurement locations, and recommend using a digital…

view full answer...

Answer 11

We do have 205/75R14 size radial tires that have a load range of D and a speed rating of at least 81 mph. Out of our available selection I recommend going with the Kenda Karrier #AM10235. This tire has a max load rating of 2,200 lbs at 75 psi and a…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Best Storage Cover for a 2018 Aliner Scout Pop-Up Camper

Product Page this Question was Asked From

Continue Researching