Vehicle and Motorhome 12V Charge Line Kits

Question

Question:

Do I need RM156-25 or RM156-75 to connect a charge line for our 2017 Jeep Unlimited? It will be towed behind our 2017 Newmar motorhome.

asked by: John T

0

Expert Reply:

You can use Roadmaster Battery Charge Line Kit for Towed Vehicles Item # RM-156-25 for your 2017 Jeep Wrangler Unlimited. If there is no charge line on your RV then you will also need the motorhome side kit # RM-156-75.

expert reply by: Adam R

0

Answer 1

In order to flat-tow your 2013 Jeep Rubicon 10th Anniversary Edition on your Forest River 2250LE, you need a base plate, a tow bar, a tow braking system, safety cables, and vehicle tow wiring. I recommend the following setup: - Blue Ox Base Plate Kit…

view full answer...

Answer 2

I have a solution for you, however, I would not recommend mounting a tow bar directly to a bumper on a Jeep, whether it is OEM or an aftermarket bumper. Jeep does not recommend towing the Wrangler with the OEM bumper because it was not designed to…

view full answer...

Answer 3

Here's how you will know if you would need the brake light relay part #RM88400 on your 2016 Jeep Wrangler with your Invisi Brake system and Hopkins wiring harness. Do the brake lights on your towed car illuminate while the engine is off? No - You…

view full answer...

Answer 4

We've been told that the battery life of the Hopkins wireless magnetic tow lights, #C6304 should be right at 2 hours. But if you use lithium batteries you should easy get double that!

view full answer...

Answer 5

The charge lines connect to the 12V pin on both the 7-way of your motorhome (1 o'clock position) and the 6-way (center pin). The wiring pigtail will ensure the connection between these pins so your motorhome will provide a maintenance charge to…

view full answer...

Answer 6

I consulted an online copy of the 2013 Jeep Wrangler Unlimited Owner's Manual, and found that the information regarding flat towing procedures begins on page number 532. The procedures outlined make no mention of what position the key needs to be…

view full answer...

Answer 7

To flat tow the 2020 Jeep Wrangler I recommend the Roadmaster Diode 7-Wire to 6-Wire Wiring Kit part #RM-15267 because of it's nice clean install. The Roadmaster kit will give you a 6-way round at the front of the Jeep with a coiled cord to…

view full answer...

Answer 8

Best option we have for charging a vehicle battery while being flat towed is the is the Roadmaster Battery Charge Line part #RM-156-25 which is specifically designed for this. Otherwise you can use a 6 or 7-way connector and wiring to give you the…

view full answer...

Answer 9

To connect the Roadmaster Battery Charge Line Kit for Towed Vehicles #RM-156-25 to your tow vehicle, you're going first want to mount the included circuit breaker with the included self tapping screws. Next, you're going to want to strip the…

view full answer...

Answer 10

Based on the information that I have you will not need to use a brake light relay on your 2014 Jeep Wrangler Rubicon when flat towing it and using a supplemental braking system. Since you will need to disconnect the battery on your vehicle you…

view full answer...

Answer 11

The wire of the Roadmaster battery charge line kit part #RM-156-25 that you referenced was designed to wire to the 12 volt accessory circuit of the trailer wiring. So yes, the pin in the 1:00 position. On a 6-way the center pin is the charge line so…

view full answer...

Answer 12

The red wire that connects to the battery on your 2016 Jeep Wrangler Unlimited will need to be attached to the silver terminal labeled as "auxiliary" on the circuit breaker that comes with the Roadmaster Battery Charge Line Kit part…

view full answer...

Vehicle and Motorhome 12V Charge Line Kits

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching