Running Light Fuse Location 2018 Chevrolet Silverado 2500

Question

Question:

What fuse in truck will it be if there is no power to trailer running lights

asked by: Gary

1

Helpful Expert Reply:

The number 15 fuse in the engine bay fuse box is responsible for the trailer parking lamps. For future reference, the owner's manual will tell you where all the fuses are located and what they do.

expert reply by: Conner L

1

Answer 1

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 2

Trailer weight distribution hitches (WDH) such as the Curt TruTrack systems #C17499 and #C17500 do come in varying weight capacities. Selection of the correct one for any given towing setup is based on the actual fully-loaded tongue weight (TW). It…

view full answer...

Answer 3

The current hitch you have on your 2018 Chevy Silverado 1500 has the towing capacity needed for the trailer you are planning on towing so there would be no need to upgrade it. For a weight distribution system the Reese Strait Line part #RP66084 would…

view full answer...

Answer 4

No, it's not sealed. Dust will work it's way into there eventually if you don't maintain it, which is why Curt directs people to brush grease on the inner and outer bearings on the top and bottom of the Curt TruTrack item #C17499 along…

view full answer...

Answer 5

The trailer running light fuse of your 2018 Chevy Silverado is in the number 15 slot of the fuse box under the hood of your truck. I attached a picture with the location pointed out.

view full answer...

Answer 6

The round or trunnion bars refers to the end of the spring bars. Round bars are typically designed for lighter applications, are a bit harder to install and are usually priced lower than trunnion bars. Trunnion bars are typically designed to be used…

view full answer...

Answer 7

I can certainly help you re-wire your trailer-side 7-Way connector. Thanks for the photo of your connector, it helped verify the style connector and which wires you have! The attached wiring diagram will help you in attaching the wires back to your…

view full answer...

Answer 8

The 4-way on your trailer is what's known as a wishbone connector like part #A35W42B. Two of the wires are the running light circuit which is a little easier to install since you can run one down each side of the trailer. This way you don't…

view full answer...

Answer 9

If you are looking for the fuses on your 2015 Chevrolet Silverado 1500 that are tied to your trailer wiring then those will be in the fuse box in the engine compartment. You can find this information as well as a list of what all the fuses are tied…

view full answer...

Answer 10

There are a few troubleshooting steps to help you figure out why you have no power. I would start by making sure that there is not any corrosion or debris blocking your connection points. If they are clean or still no power after cleaning, I would…

view full answer...

Answer 11

The wire colors on the Hopkins replacement 7/4-Way trailer connector #30955 are as follows: White is ground Black is 12 volt power Green is right turn/brake lights Yellow is left turn/brake lights Blue is output from a brake controller to trailer…

view full answer...

Answer 12

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the…

view full answer...

Running Light Fuse Location 2018 Chevrolet Silverado 2500

Product Page this Question was Asked From

Continue Researching