Installation of Furrion 30 Amp Shore Power Inlet

Question

Question:

Hi- Furrion installation instructions call for mounting with PA3.5x30 screws. Not sure what these screws are, can you describe or send photos or ideally sell me a package of them? Thanks

asked by: Richard S

1

Helpful Expert Reply:

The Furrion 30 Amp Power Inlet - White - LED # 431861 will use 3.5mm x 30mm screws. These are No. 6 screws. You can find these at any local hardware store. You will want these to be stainless steel screws so they can tolerate the exposure to outside elements.

Unfortunately we don't have this hardware.

expert reply by: Jason S

1

Answer 1

There is not a plug and play adapter for your Lance connector that we are aware of. Typically this is installed by the Lance dealer. A junction box/7-way plug kit like #HS381-9000 is an option you have to convert the camper to match the 7-way RV…

view full answer...

Answer 2

While the Rack'Em Fitz-All Enclosed Trailer Ladder Rack #RA-28 was designed to fit on trailer with a rain gutter, we have had several install it on their trailer without rain gutters. I have also included our review video below where you can…

view full answer...

Answer 3

Yes, the Furrion #A10-3025ED cord will work as a replacement for your original damaged Marinco shore power cord if your 2019 Airstream Flying Cloud came equipped with one air conditioner, and is therefore running 30 Amp service (standard on all…

view full answer...

Answer 4

The USB Outlet with Waterproof Cap #DG61USBVP requires a 1-1/8" depth without the cap. The cap for the face has a ring that slides onto the shaft and is approximately 5/16" thick. If you plan on using the cap then the ring portion of it…

view full answer...

Answer 5

I reached out to my contact at Diamond and she said that the USB Outlet #DG61USBVP has a 2.1 amp max rating. I have attached a short video review that you can check out as well.

view full answer...

Answer 6

What you have there is an obsolete Bargman 35 amp power inlet. There ARE adapters out there, but they are VERY rare and therefore expensive. I'd recommend removing it and installing a modern 30 amp inlet like part #A10-30INVP along with a 30 amp…

view full answer...

Answer 7

Though we do not have specific parts lists for certain trailers, to determine the brake assemblies that will fit your 2007 Sundowner, you need to know your axle's weight capacity, the size of your wheels, your mounting flange bolt pattern and the…

view full answer...

Answer 8

The Electric Brake Kit #AKEBRK-7-SA should be what you're needing. Even though these are only rated for up to a 7K axle they should be sufficient for your trailer. All you need to do is verify that the inside diameter of your hub and drum…

view full answer...

Answer 9

In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along with…

view full answer...

Installation of Furrion 30 Amp Shore Power Inlet

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching